HMC1197LP7FE datasheet(4/57 Pages) AD

4 / 57 page

For price, delivery, and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824

Phone: 978-250-3343

Fax: 978-250-3373

Order On-line at www.hittite.com

Application Support: Phone: 978-250-3343 or apps@hittite.com

HMC1197LP7FE

v03.0314

Wideband direct Quadrature Modulator

w/ Fractional-n Pll & Vco, 100 - 4000 MHz

calibrated vs. uncalibrated test results

During the Uncalibrated Sideband and Carrier Suppression tests, care is taken to ensure that the I/Q signal paths

from the Vector Signal Generator (VSG) to the Device Under Test (DUT) are equal. The “Uncalibrated” Sideband and

Carrier Suppression plots were measured at T= -40 °C, +25 °C, and +85 °C.

The “Calibrated” Sideband Suppression data was plotted after a manual adjustment of the I/Q amplitude balance and

I/Q phase offset (skew) at +25 °C, 5V and 3.3V Vcc, LO maximum power level. The +25 °C adjustment settings were

held constant during tests over temperature.

The “Calibrated” Carrier Suppression data was plotted after a manual adjustment of the IP/IN & QP/QN DC offsets at

+25 °C, 5V and 3.3V Vcc, LO maximum power level. The +25 °C adjustment settings were held constant during tests

over temperature.

table 4. Filter bank Selection vs. Frequency

Frequency

(MHz)

≤ 500

600 700 800 900

1000/1100

1200

1300/1400/1500 1600 1700/1800 1900/2000

2000 ≥

Frequency

(MHz)

≤ 500

600 700 800 900

1000/1100

1200

1300/1400/1500 1600 1700/1800 1900/2000

2000 ≥

Filter Bank

Selection

table 3. test conditions: unless otherwise Specified, the Following test conditions Were used

Parameter

Condition

Temperature

+25 °C

Baseband Input Frequency

200 kHz

Baseband Input DC Voltage (Vbbdc)

+0.5 V

Baseband Input AC Voltage

(Peak to Peak Differential, I and Q)

1.0 V

Baseband Input AC Voltage for OIP3 Measurements (Peak to Peak Differential, I and Q)

500 mV per tone @ 150 & 250 KHz

Baseband Input AC Voltage for Noise Floor Measurements (Peak to Peak Differential, I and Q)

no baseband input voltage

Frequency Offset for Output Noise Measurements

20 MHz

Supply Voltage (VCC1, VCC2, VCC3, VDDLS, VDDCP, BIAS)

+5.0V

Supply Voltage (V3, DVDD, RVDD, VCCPD, VCCPS, VCCHF)

+3.3V

LO Power Level

Maximum Power

Mounting Configuration

Refer to HMC1197LP7FE Application Schematic

Herein

Sideband & Carrier Feedthrough

Uncalibrated

table 2. electrical Specifications (Continued)

Parameter

Conditions

Min.

Typ.

Max.

Units

VCO Characteristics

VCO Tuning Sensitivity at 3862 MHz

Measured at 2.5 V

MHz/V

VCO Tuning Sensitivity at 3643 MHz

Measured at 2.5 V

14.5

MHz/V

VCO Tuning Sensitivity at 3491 MHz

Measured at 2.5 V

16.2

MHz/V

VCO Tuning Sensitivity at 3044 MHz

Measured at 2.5 V

14.6

MHz/V

VCO Tuning Sensitivity at 2558 MHz

Measured at 2.5 V

15.4

VCO Tuning Sensitivity at 2129 MHz

Measured at 2.5 V

14.8

VCO Supply Pushing

Measured at 2.5 V

MHz/V

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other

rights of third parties that may result from its use. Specifications subject to change without notice. No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarks and registered trademarks are the property of their respective owners.

For price, delivery, and to place orders: Analog Devices, Inc.,

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106

Phone: 781-329-4700 • Order online at www.analog.com

Application Support: Phone: 1-800-ANALOG-D

HMC1197LP7FE 数据表(PDF) 4 Page - Analog Devices

HMC1197LP7FE 数据表(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

数据表下载

链接网址

HMC1197LP7FE 数据表(PDF) 4 Page - Analog Devices

HMC1197LP7FE 数据表(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

数据表 下载

链接网址

数据表下载