HMC1197LP7FE datasheet(19/57 Pages) AD

19 / 57 page

For price, delivery, and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824

Phone: 978-250-3343

Fax: 978-250-3373

Order On-line at www.hittite.com

Application Support: Phone: 978-250-3343 or apps@hittite.com

HMC1197LP7FE

v03.0314

Wideband direct Quadrature Modulator

w/ Fractional-n Pll & Vco, 100 - 4000 MHz

be any rational number supported by the N divider.

N is set by the integer (Nint = Reg 03h) and fractional (Nfrac = Reg 04h) register contents

N = N

int + Nfrac / 2

(EQ 2)

The AutoCal state machine runs at the rate of the FSM clock, TFSM, where the FSM clock frequency cannot

be greater than 50 MHz.

FSM = Txtal · 2

(EQ 3)

is 0, 2, 4 or 5 as determined by Reg 0Ah[14:13]

The expected number of VCO counts, V, is given by

V = floor (N · 2

(EQ 4)

The nominal VCO frequency measured, fvcom, is given by

vcom = V · fxtal / (2

n · R)

(EQ 5)

where the worst case measurement error, ferr , is:

err ≈ ±fpd / 2

n + 1

(EQ 6)

Figure 37. VCO Calibration

A 5-bit step tuned VCO, for example, nominally requires 5 measurements for calibration, worst case 6

measurements, and hence 7 VSPI data transfers of 20 clock cycles each. Total calibration time, worst

case, is given by:

cal = k128TFSM + 6TPD 2

n + 7 · 20T

FSM

(EQ 7)

or equivalently

cal = Txtal (6R · 2

n + (140+(3 · 128)) · 2m)

(EQ 8)

For guaranteed hold of lock, across temperature extremes, the resolution should be better than

1/8th the frequency step caused by a VCO sub-band switch change. Better resolution settings will show

no improvement.

1.2.1.4.1.1

Vco autocal example

The HMC1197LP7FE must satisfy the maximum fpd limited by the two following conditions:

a. N ≥ 16 (fint), N ≥ 20.0 (ffrac), where N = fVCO/ fpd

b. fpd ≤ 100 MHz

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other

rights of third parties that may result from its use. Specifications subject to change without notice. No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarks and registered trademarks are the property of their respective owners.

For price, delivery, and to place orders: Analog Devices, Inc.,

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106

Phone: 781-329-4700 • Order online at www.analog.com

Application Support: Phone: 1-800-ANALOG-D

HMC1197LP7FE 数据表(PDF) 19 Page - Analog Devices

HMC1197LP7FE 数据表(HTML) 19 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

数据表下载