IOBUS0 datasheet(52/88 Pages) FTDI

52 / 88 page

C opyright © Future T ec hnology Devic es I nternational Limited

Datasheet

Vinculum-II Embedded Dual USB Host Controller IC

V ers ion 1 .7

Doc ument N o.: FT _000138 C learance N o.: FT DI# 1 43

Figure 6.18 SPI Slave Mode Data Write

6.3.6.4 SPI Master Status Read Transaction in VNC1L legacy mode

The VNC2 has a status byte which determines the state of the Receive and Transmit Buffers. The SPI

master must poll VNC2 and read the status byte.

The Start and Setup sequence is sent to VNC2 by the SPI master, see Figure 6.19. The VNC2 clocks out

its status byte on subsequent rising edge clock cycles from the SPI master. This is followed by a status

bit generated by VNC2 (also on the MISO) which will always be zero (indicating new data).

The meaning of the bits within the status byte sent by VNC2 during a Status Read operation is described

in Table 6.12. The result of the Status Read transaction is only valid during the transaction itself. Data

read and data write transactions must still check the status bit during a Data Read or Data Write cycle

regardless of the result of a Status Read operation.

Bit

Description

RXF#

Receive Buffer Full

TXE#

Transmit Buffer Empty

Not used

RXF IRQEn

Receive Buffer Full Interrupt Enable

TXE IRQEn

Transmit Buffer Empty Interrupt Enable

Not used

Table 6.12 SPI Status Read Byte – bit descriptions

Figure 6.19 SPI Slave Mode Status Read

IOBUS0 数据表(PDF) 52 Page - Future Technology Devices International Ltd.