| 数据搜索系统,热门电子元器件搜索 |
|
TNETX15AE 数据表(PDF) 73 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TNETX15AE 数据表(HTML) 73 Page - Texas Instruments |
|
73 / 78 page ![]() TNETX15AE ADDRESS-LOOKUP DEVICE SPWS041A – AUGUST 1997 – REVISED OCTOBER 1997 73 POST OFFICE BOX 655303 • DALLAS, TEXAS 75265 operating characteristics over recommended operating conditions (see Note 8 and Figure 26) EEPROM and MDIO (MII) interfaces When the host is driving the EEPROM interface through the SIO register (0x0A), the output terminals are copies of register bits synchronized by OSCIN rising, and the input register bits are copies of the device terminals synchronized by OSCIN rising. This adds a maximum of 20 ns of delay in each direction, which is negligible in terms of the maximum signal change rate allowed for the EEPROMs (approximately 100 kHz), or the MDIO (MII management). The timing for these interfaces is set at the rate that register bits are set in software. For detailed descriptions of the EEPROM requirements, refer to the data sheet for the part in question. For detailed descriptions of the MII management interface, refer to IEEE Std 802.3. When the TNETX15VE is driving the EEPROM during the automatic register load cycle, the timing on the EEPROM is as shown in Figure 26. EEPROM interface timing (TNETX15AE to EEPROM transfer) (see Note 8) NO. PARAMETER† MIN MAX UNIT fclock Clock frequency, ECLK 98 kHz 1 tw(ECLKL)1 Pulse duration, ECLK low during start/stop 10.24 µs 2 tw(ECLKH)1 Pulse duration, ECLK high during start/stop 10.2 µs 3 tw(ECLKH)2 Pulse duration, ECLK high during data 5.1 µs 4 tw(ECLKL)2 Pulse duration, ECLK low during data 5.12 µs 5 td(EDIO)1 Delay time, from ECLK ↑ to EDIO↓, start condition 5.1 µs 6 td(ECLK)1 Delay time, from EDIO ↓ to ECLK↓, start condition 5.1 µs 7 td(EDIO)2 Delay time, from ECLK ↓ to EDIO↑, data condition 0 µs 8 td(ECLK)2 Delay time, from EDIO ↑ to ECLK↑, data condition 5.1 µs 9 td(EDIO)3 Delay time, from OSCIN to EDIO 18 ns 10 td(ECLK)3 Delay time, from OSCIN to ECLK 18 ns † These parameters are specified by design, but not tested. NOTE 8: The timing for the EEPROM interface occurs with the ETEST bit set to 0. ECLK (Output) EDIO (Output) Valid 2 1 4 3 56 7 8 Figure 26. EEPROM Interface Timing |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |