GLS53 datasheet(40/109 Pages) EMERSON-NETWORKPOWER

40 / 109 page

GLS200-M Series Installation & Operating Instructions

Visit our Web site at www.solahd.com or contact Technical Support at (800) 377- 4384 with any questions.

P/N: A272-197 Rev 0 5/11/09 Ref: 03366205860

To comply with the published safety standards, the following must be observed when using

this power supply:

1. Maximum ambient temperature for the power supply must not exceed 50°C. Derate

each output 2.5% per degree from 50°C to 70°C ambient temperature.

2. When installing the power supply in the end-use equipment, special attention is

required to ensure safety compliance with the following safety standards: UL60950-1,

EN60950-1, IEC60950-1, CSA22.2 No. 60950-1-03, UL60601-1, EN60601-1,

IEC60601-1, and CSA22.2 No. 601.1. The safety requirements include creepage

distances, clearances, and distance through insulation between primary wiring and

earth or secondary (SELV) wiring.

3. The ac-dc input connector is approved as a component of the power supply, however, it

was not specifically evaluated to IEC60320.

4. This power supply is approved and certified for the rated voltage range of 100 V ac to

250 V ac and/or 120 V dc minimum to 300 V dc maximum.

5. The maximum output power of the supply must not exceed the rating indicated in the

specification sheet.

6. The earth ground wire must be connected only to the point marked with the earth

ground symbol (on the unit).

7. The disconnection from the line must be in the end system.

8. Hazardous voltages exist in the primary circuits. Disconnect power supply before

servicing.

9. When operating with a dc input voltage range, the unit must be protected by a dc rated

fuse in the end-use installation system.

10. The internal fuses (F1 & F2) should only be replaced with a F5AH, 250 V ac, type 50CF

manufactured by Hollyland or type 216005.MXEP manufactured by Littelfuse.

NOTE: The power supply has a fuse on the neutral line.

11. The power supply has no patient applied part.

12. This equipment is considered Class I according to protection against electric shock.

13. This power supply is

marked following the provisions of the Low Voltage Directive,

2006/95/EC.

14. For technical assistance, contact SolaHD Technical Support at (800) 377- 4384 or send

an e-mail to tech@solahd.com. Please visit our Web site at www.solahd.com for addi-

tional product information and specification sheets.

Output Ratings

Model

Output Voltage

(V)

Convection Cooling

30 CFM Forced Air Cooling

Max. Output

Current (A)

Max. Output

Power (W)

Max. Output

Current (A)

Max. Output

Power (W)

GLS202-M

20.0

100

40.0

200

+12_FAN

0.5

1.0

GLS203-M

+12

10.4

125

20.83

250

+12_FAN

0.5

1.0

GLS204-M

+15

8.3

16.6

+12_FAN

0.5

1.0

GLS205-M

+24

5.2

10.4

+12_FAN

0.5

1.0

GLS208-M

+48

2.6

5.2

+12_FAN

0.5

1.0

Connector PIN Designation

Input Connector

Designation

SK1

Neutral

Line

Earth GND

Output Connector

Designation

SK2

Common

Main output

SK3

+Remote sense

-Remote sense

N/C

Power fail

Common

N/C

Common

+12 V_FAN

+12 V_FAN return

GLS53 数据表(PDF) 40 Page - Emerson Network Power

GLS53 数据表(HTML) 40 Page - Emerson Network Power

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载

链接网址

GLS53 数据表(PDF) 40 Page - Emerson Network Power

GLS53 数据表(HTML) 40 Page - Emerson Network Power

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表 下载

链接网址

数据表下载