 |
数据搜索系统，热门电子元器件搜索 |
|
|
数据搜索系统，热门电子元器件搜索 |
|
GLS53 数据表(PDF) 28 Page - Emerson Network Power |
|
|
|||||||||||||||||||||||||||||
GLS53 数据表(HTML) 28 Page - Emerson Network Power |
|
|
28 / 109 page  GLS120 Series Installation & Operating Instructions Visit our Web site at www.solahd.com or contact Technical Support at (800) 377- 4384 with any questions P/N: A272-190 Rev 0 5/1/09 Ref: 03366202940/LPS123/OP To comply with the published safety standards, the following must be observed when using this power supply: 1. Maximum ambient temperature for the power supply must not exceed 50°C. Derate each output 2.5% per degree from 50°C to 70°C ambient temperature. 2. When installing the power supply in the end-use equipment, special attention is required to ensure safety compliance with the following safety standards: UL60950-1, EN60950-1, IEC60950-1, and CSA22.2 No. 60950-1-03; including the requirements for creepage distances, clearances and distance through insulation between primary wiring and earth or secondary (SELV) wiring. 3. The ac-dc input connector is approved as a component of the power supply, however, it was not specifically evaluated to IEC60320. 4. This power supply is approved and certified for the rated voltage range of 100 V ac to 250 V ac and/or 120 V dc (minimum) to 300 V dc (maximum). 5. The maximum output power of the supply must not exceed the rating indicated in the specification sheet. 6. The earth ground wire must be connected only to the point marked with the earth ground symbol (on the unit). 7. The disconnection from the line must be in the end system. 8. Hazardous voltages exist in the primary circuits. Disconnect power supply before servicing. 9. When operating with a dc input voltage range, the dc source must be rectified from a mains supply not exceeding 250 V ac. The unit input must also be protected by a dc rated fuse in the end-use installation system. 10. The internal fuse (F1) should only be replaced by a 4AH, 250 V ac, type GDA-V/S501 manufactured by Bussmann, type 216004.MXEP manufactured by Littelfuse, or type 19194 manufactured by Wickmann. 11. This equipment is considered Class I according to protection against electric shock. 12. This power supply is marked following the provisions of the Low Voltage Directive, 2006/95/EC. 13. For technical assistance, contact SolaHD Technical Support at (800) 377- 4384 or send an e-mail to tech@solahd.com. Please visit our Web site at www.solahd.com for addi- tional product information and specification sheets. Mechanical Outline SK- SK+ SK3 1 9 2 10 V Adj. Pot N L CN1 P1 Connector PIN Designation Input Connector PIN Designation CN1 Neutral Line P1 Earth Output Connector PIN Designation SK- Common SK+ Main output SK3 1 +Power fail 2 +5 VSTBY 3 -Remote inhibit 4 +12 V common 5 +Remote inhibit 6 +12 V (FAN_OUT) 7 -Remote sense 8 SWP (Single wire parallel) 9 +Remote sense 10 Common Output Ratings Model Output Voltage (V) Convection Cooling 30 CFM Forced Air Cooling Max. Output Current (A) Max. Output Power (W) Max. Output Current (A) Max. Output Power (W) GLS122 +5 16.0 80 26.0 130 +12 (FAN_OUT) 0.5 0.5 +5 VSTBY 0.5 0.5 GLS123 +12 6.7 10.8 +12 (FAN_OUT) 0.5 0.5 +5 VSTBY 0.5 0.5 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
