ST25R3916 datasheet(73/157 Pages) STMICROELECTRONICS

73 / 157 page

DS12484 Rev 4

73/157

ST25R3916/7

Application information

156

4.5.3

Operation control register

Address: 02h

Type: RW

Table 21. Operation control register(1)

Bit

Name

Default

Function

Comments

7en

1: Enables oscillator and regulator

(Ready mode)

rx_en

1: Enables Rx operation

rx_chn

0: Both, AM and PM, channels

enabled

1: One channel enabled

If only one Rx channel is enabled, selection is

done by the Receiver configuration register 1 bit

ch_sel.

4rx_man

0: Automatic channel selection

1: Manual channel selection

If both Rx channels are enabled, chooses the

method of channel selection, manual selection is

done by the Receiver configuration register 1 bit

ch_sel.

tx_en

1: Enables Tx operation

This bit is automatically set by NFC Field ON

commands and reset in NFC active

communication modes after transmission is

finished.

1: Enables Wake-up mode

According to settings in Wake-up timer control

en_fd_c1

00: External field detector off.

01: Manually enable external field

detector with collision avoidance

detection threshold.

10: Manually enable external field

detector with peer detection

threshold.

11: Enable external field detector

automatically.

11: External field detector with peer

detection/collision avoidance threshold activated

automatically (used for NFCIP-1 P2P modes).

en_fdc1:0>0 and other bits in this register are set

to 0 put device in a low power initial NFC mode.

en_fd_c0

1. Default setting takes place at power-up only.

ST25R3916 数据表(PDF) 73 Page - STMicroelectronics

ST25R3916 数据表(HTML) 73 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载