ST7LUS5 datasheet(37/124 Pages) STMICROELECTRONICS

37 / 124 page

ST7LUS5, ST7LU05, ST7LU09

Interrupts

37/124

Interrupts

The ST7 core may be interrupted by one of two different methods: Maskable hardware

interrupts as listed in Table 15: Interrupt mapping on page 39 and a non-maskable software

interrupt (TRAP). The interrupt processing flowchart is shown in Figure 13.

The maskable interrupts must be enabled by clearing the I bit in order to be serviced.

However, disabled interrupts may be latched and processed when they are enabled (see

Section 7.2: External interrupts).

Note:

After reset, all interrupts are disabled.

When an interrupt has to be serviced:

●

Normal processing is suspended at the end of the current instruction execution.

●

The PC, X, A and CC registers are saved onto the stack.

●

The I bit of the CC register is set to prevent additional interrupts.

●

The PC is then loaded with the interrupt vector of the interrupt to service and the first

instruction of the interrupt service routine is fetched (refer to Table 15: Interrupt

mapping for vector addresses).

The interrupt service routine should finish with the IRET instruction which causes the

contents of the saved registers to be recovered from the stack.

Note:

As a consequence of the IRET instruction, the I bit is cleared and the main program

resumes.

Priority management

By default, a servicing interrupt cannot be interrupted because the I bit is set by hardware

entering in interrupt routine.

In the case when several interrupts are simultaneously pending, an hardware priority

defines which one will be serviced first (see Table 15: Interrupt mapping).

Interrupts and Low Power mode

All interrupts allow the processor to leave the Wait low power mode. Only external and

specifically mentioned interrupts allow the processor to leave the Halt low power mode (refer

to the “Exit from HALT” column in Table 15: Interrupt mapping).

7.1

Non-maskable software interrupt

This interrupt is entered when the TRAP instruction is executed regardless of the state of

the I bit. It is serviced according to the flowchart in Figure 13.

7.2

External interrupts

External interrupt vectors can be loaded into the PC register if the corresponding external

interrupt occurred and if the I bit is cleared. These interrupts allow the processor to leave the

Halt low power mode.

The external interrupt polarity is selected through the miscellaneous register or interrupt

ST7LUS5 数据表(PDF) 37 Page - STMicroelectronics

ST7LUS5 数据表(HTML) 37 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载