M58LR128HT datasheet(19/112 Pages) STMICROELECTRONICS

19 / 112 page

M58LR128HT, M58LR128HB

Command interface

19/112

4.3

Read Electronic Signature command

The Read Electronic Signature command is used to read the Manufacturer and Device

Codes, the Lock Status of the addressed bank, the Protection Register, and the

Configuration Register.

One Bus Write cycle is required to issue the Read Electronic Signature command. Once a

bank is in Read Electronic Signature mode, subsequent read operations in the same bank

will output the Manufacturer Code, the Device Code, the Lock Status of the addressed bank,

the Protection Register, or the Configuration Register (see Table 8).

The Read Electronic Signature command can be issued at any time, even during program or

erase operations, except during Protection Register Program operations. Dual operations

between the Parameter bank and the Electronic Signature location are not allowed (see

Table 15: Dual operation limitations for details).

If a Read Electronic Signature command is issued to a bank that is executing a program or

erase operation the bank will go into Read Electronic Signature mode. Subsequent Bus

Read cycles will output the Electronic Signature data and the Program/Erase controller will

continue to program or erase in the background.

The Read Electronic Signature command will only change the read mode of the addressed

bank. The read modes of other banks are not affected. Only Asynchronous Read and Single

Synchronous Read operations should be used to read the Electronic Signature. A Read

Array command is required to return the bank to Read Array mode.

4.4

Read CFI Query command

The Read CFI Query command is used to read data from the Common Flash Interface

(CFI).

One Bus Write cycle is required to issue the Read CFI Query command. Once a bank is in

Read CFI Query mode, subsequent Bus Read operations in the same bank read from the

Common Flash Interface.

The Read CFI Query command can be issued at any time, even during program or erase

operations.

If a Read CFI Query command is issued to a bank that is executing a program or erase

operation the bank will go into Read CFI Query mode. Subsequent Bus Read cycles will

output the CFI data and the Program/Erase controller will continue to program or erase in

the background.

The Read CFI Query command will only change the read mode of the addressed bank. The

read modes of other banks are not affected. Only Asynchronous Read and Single

Synchronous Read operations should be used to read from the CFI. A Read Array

command is required to return the bank to Read Array mode. Dual operations between the

Parameter Bank and the CFI memory space are not allowed (see Table 15: Dual operation

limitations for details).

See Appendix B: Common Flash Interface, Tables 32, 33, 34, 35, 36, 37, 38, 39, 40 and 41

for details on the information contained in the Common Flash Interface memory area.

M58LR128HT 数据表(PDF) 19 Page - STMicroelectronics

M58LR128HT 数据表(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载