H8SLASH3003 datasheet(353/715 Pages) RENESAS

353 / 715 page

Sample Setup Procedure for PWM Mode: Figure 10-28 shows a sample procedure for setting

up PWM mode.

Figure 10-28 Setup Procedure for PWM Mode (Example)

PWM mode

1. Set bits TPSC2 to TPSC0 in TCR to

select the counter clock source. If an

external clock source is selected, set

bits CKEG1 and CKEG0 in TCR to

select the desired edge(s) of the

external clock signal.

PWM mode

Select counter clock

Select counter clear source

Set GRA

Set GRB

Select PWM mode

Start counter

2. Set bits CCLR1 and CCLR0 in TCR

to select the counter clear source.

3. Set the time at which the PWM

waveform should go to 1 in GRA.

4. Set the time at which the PWM

waveform should go to 0 in GRB.

5. Set the PWM bit in TMDR to select

PWM mode. When PWM mode is

selected, regardless of the TIOR

contents, GRA and GRB become

output compare registers specifying

the times at which the PWM

goes to 1 and 0. The TIOCA pin

automatically becomes the PWM

output pin. The TIOCB pin conforms

to the settings of bits IOB1 and IOB0

in TIOR. If TIOCB output is not

desired, clear both IOB1 and IOB0 to 0.

6. Set the STR bit to 1 in TSTR to start

the timer counter.

335

H8/3003 数据表(PDF) 353 Page - Renesas Technology Corp

H8/3003 数据表(HTML) 353 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载