H8SLASH3003 datasheet(357/715 Pages) RENESAS

357 / 715 page

Sample Setup Procedure for Reset-Synchronized PWM Mode: Figure 10-31 shows a sample

procedure for setting up reset-synchronized PWM mode.

Figure 10-31 Setup Procedure for Reset-Synchronized PWM Mode (Example)

Reset-synchronized PWM mode

1. Clear the STR3 bit in TSTR to 0 to

halt TCNT3. Reset-synchronized

PWM mode must be set up while

TCNT3 is halted.

Reset-synchronized PWM mode

Stop counter

Select counter clock

Select counter clear source

Select reset-synchronized

PWM mode

Set TCNT

Set general registers

2. Set bits TPSC2 to TPSC0 in TCR to

select the counter clock source for

channel 3. If an external clock source

is selected, select the external clock

edge(s) with bits CKEG1 and CKEG0

in TCR.

3. Set bits CCLR1 and CCLR0 in TCR3

to select GRA3 compare match as

the counter clear source.

4. Set bits CMD1 and CMD0 in TFCR to

select reset-synchronized PWM mode.

TIOCA3, TIOCB3, TIOCA4, TIOCB4,

TOCXA4, and TOCXB4 automatically

become PWM output pins.

5. Preset TCNT3 to H'0000. TCNT4

need not be preset.

Start counter

6. GRA3 is the waveform period register.

Set the waveform period value in

GRA3. Set transition times of the

PWM output waveforms in GRB3,

GRA4, and GRB4. Set times within

the compare match range of TCNT3.

GRA3 (X: setting value)

≤

7. Set the STR3 bit in TSTR to 1 to start

TCNT3.

339

H8/3003 数据表(PDF) 357 Page - Renesas Technology Corp

H8/3003 数据表(HTML) 357 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载