MFRC522 datasheet(16/96 Pages) NXP

16 / 96 page

MFRC522_33

Product data sheet

PUBLIC

Rev. 3 — 26 October 2009

112133

16 of 96

NXP Semiconductors

MFRC522

Contactless reader IC

8.1.4.1

Data validity

Data on the SDA line must be stable during the HIGH clock period. The HIGH or LOW

state of the data line must only change when the clock signal on SCL is LOW.

8.1.4.2

START and STOP conditions

To manage the data transfer on the I2C-bus, unique START (S) and STOP (P) conditions

are deﬁned.

• A START condition is deﬁned with a HIGH-to-LOW transition on the SDA line while

SCL is HIGH.

• A STOP condition is deﬁned with a LOW-to-HIGH transition on the SDA line while

SCL is HIGH.

The I2C-bus master always generates the START and STOP conditions. The bus is busy

after the START condition. The bus is free again a certain time after the STOP condition.

The bus stays busy if a repeated START (Sr) is generated instead of a STOP condition.

The START (S) and repeated START (Sr) conditions are functionally identical. Therefore,

S is used as a generic term to represent both the START (S) and repeated START (Sr)

conditions.

8.1.4.3

Byte format

Each byte must be followed by an acknowledge bit. Data is transferred with the MSB ﬁrst;

see Figure 16. The number of transmitted bytes during one data transfer is unrestricted

but must meet the read/write cycle format.

Fig 12. Bit transfer on the I2C-bus

mbc621

data line

stable;

data valid

change

of data

allowed

SDA

SCL

Fig 13. START and STOP conditions

mbc622

SDA

SCL

STOP condition

SDA

SCL

START condition

MFRC522 数据表(PDF) 16 Page - NXP Semiconductors

MFRC522 数据表(HTML) 16 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96

数据表下载