AD9739-R2-EBZ datasheet(36/48 Pages) AD

36 / 48 page

AD9739

Data Sheet

Rev. B | Page 36 of 48

DB0[13:0]

DB1[13:0]

DCI

DB0

EVEN

DB0

ODD

DB1

EVEN

DB1

ODD

DCO

fDAC/4

SYNC_IN

SYNC_OUT

DIV-BY-4

0/180

RX DATA CONTROLLER

90/270

STATE MACHINE

TRACKING LOOP

PHASE

ROTATOR

SLAVE ONLY

TO DAC

DELAY

fDAC

Mu Delay

MU DELAY

fDAC DISTRIBUTION

SYNCHRONIZATION CONTROLLER

180

270

DIV-BY-4

DELAY

STATE MACHINE

TRACKING LOOP

PHASE

COMPARISON

Figure 53. Top Level Block Diagram of Synchronization Circuitry and Controller

Figure 53 shows a top-level diagram of the synchronization

controller (bottom) and how it interfaces to other digital

functional blocks within the AD9739. Note the following

observations of this top level diagram:

•

Synchronization between multiple devices is achieved by

rotating the div-by-4 phases of the slave devices such that

they align with the master.

•

For the slave devices, the sync controller compares the phase

alignment of the master’s SYNC_IN reference signal with

the initial 0o/90o outputs of the div-by-4 and then rotates

the div-by-4 phase until the SYNC_IN signal falls between

these phases.

•

A reference signal common to all devices is required for

synchronization. The master device generates this signal by

providing a SYNC_OUT signal which is then distributed to

all the devices (including itself with tight time alignment)

as a SYNC_IN signal.

•

Because the SYNC_IN signal has a defined relationship

between the div-by-4 phase of the master, the slave devices can

now align their respective div-by-4 phases to the SYNC_IN

phase thus ensuring phase alignment among all devices.

•

It is not possible to manually rotate the div-by-4 phases of

the data path with the sync controller enabled. This can be

a problem at lower clock rates were one may desire to rotate

the div-by-4 phase to ensure locking of the data receiver

controller and/or achieve a more optimum DCI_DEL value.

•

The DCO output signal is generated from a separate div-

by-4 circuit, and therefore, has a random phase upon each

startup. For this reason, the DCO of the master should be

distributed to all the FPGAs.

SYNC Controller Initialization Description

The sync controller of the master is enabled by writing 0x70 to

the output delay of its SYNC_OUT signal such that the fed back

reference SYNC_IN signal is centered between the 0° and 90°

output phases associated with its div-by-4 circuit. Note that the

coarse delay is performed by shifting phases via PHZ MUX while

the fine delay that centers (and tracks) variation is done by a

variable delay line. The variable delay line tap size is 12 ps. Once

SYNC_IN is centered, the controller enters tracking mode such

that SYNC_IN remains centered despite possible system variations

in temperature and/or supply. Centering the SYNC_IN signal

on the master device ensures that the SYNC_IN signals of the slave

AD9739-R2-EBZ 数据表(PDF) 36 Page - Analog Devices

AD9739-R2-EBZ 数据表(HTML) 36 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表下载