STLUX datasheet(70/126 Pages) STMICROELECTRONICS

70 / 126 page

Option bytes

STLUX

70/126

DocID027870 Rev 1

nUBC (UBC user boot code register protection)

nUBC: not (UBC) EMC byte protection.

GENCFG (general configuration register)

Bit 0:

EN_COLD_CFG enables IC cold configuration through the option byte register

AFR_IOMXP0, P1 and P2:

0: default case, the IC multifunction signal configuration is performed by the

miscellaneous registers MSC_IOMXP0, MSC_IOMXP1 and MSC_IOMXP2 (warm

configuration).

1: enables the multifunction signal configuration through the option byte registers

AFR_IOMXP0, AFR_IOMXP1 and AFR_IOMXP2 (cold configuration).

Bit 1:

COMP1_2 enables the complete backward compatibility with the STLUX385 IC device.

Bit 7:2:

Rst_PWM [5:0] configures the PWM [n] reset value after the NRST signal

0: PWM [n] output low level (native default value)

1: PWM [n] output high level.

Note:

The PWM signal programmed reset value is configured during the option byte loader phase,

then before the NRST is released it assumes its proper initial values.

The Rst_PWM5 is not available only on the STLUX325A and must be kept 0.

The Rst_PWM5 and Rst_PWM4 are not available only on the STLUX325A and must be

kept 0.

Table 43. nUBC (UBC user boot code register protection)

Offset: 0x004802

Default value: 0xFF

654

nUBC [7:0]

r/w

Table 44. GENCFG (general configuration register)

Offset: 0x004803

Default value: 0x00

Rst_PWM [5:0]

COMP1_2(1)

1. Available only on the STLUX385A and STLUX383A, otherwise keep 0.

EN_COLD_C FG

r/w

STLUX 数据表(PDF) 70 Page - STMicroelectronics

STLUX 数据表(HTML) 70 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载