EPC635 datasheet(84/97 Pages) EPC

84 / 97 page

8.7.6. LED_driver

LED_driver

Mod./demod. registers, SEG1 *: LED driver

0x90

Bit No.

Bit name

led_drv_sel

led2_en

led_on

reserved

led_drv_en

led_inv_en

led_ssr_en

Operation

Default

0xC4

led_drv_sel:

LED driver output max. current select e.g. for LED current 200mA

≙ 100%

00:

33%

01:

46%

10:

64%

11: 100%

0.0

0.2

0.4

0.6

0.8

1.0

1.2

1.4

1.6

0.1

0.2

0.3

0.4

0.5

0.6

0.7

I_LED led_drv_sel = 11

I_LED led_drv_sel = 01

I_LED led_drv_sel = 10

I_LED led_drv_sel = 00

VDD_LED (V)

Figure 69: Output characteristic ILED versus VDDLED

Refer for maximum values of VDDLED and ILED to Table 1.

led2_en:

LED2 pin enable

0: disabled (i.e. 0V)

1: enabled

led_on:

LED/LD permanently on (DC) (torch function)

0: off

1: on

led_drv_en:

LED driver internal power enable (independent of the modulator)

0: disable

1: enable

led_inv_en:

LED signal inversion. Inversion of the output levels of the LED signal.

0: disable (signal is active when pin LED = 0, VSSLED)

1: enable (signal is active when pin LED = 1, open-drain)

Note: When led_inv_en = 0: It can directly sink the LED turn-on current without additional external driver.

When led_inv_en = 1: It needs an external pull-up resistor (open-drain) to drive the inverted value for the

external LED drive circuitry.

led_ssr_en:

LED slow slew rate enable.

0: disable

1: enable

Characteristics subject to change without notice

84 / 97

Datasheet_epc635-V1.02

EPC635 数据表(PDF) 84 Page - Espros Photonics corp

EPC635 数据表(HTML) 84 Page - Espros Photonics corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

数据表下载