| 数据搜索系统,热门电子元器件搜索 |
|
NET2890 数据表(PDF) 16 Page - List of Unclassifed Manufacturers |
|
|
|||||||||||||||||||||||||||||
NET2890 数据表(HTML) 16 Page - List of Unclassifed Manufacturers |
|
16 / 73 page ![]() Specification NET2890 USB Interface Controller ____________________________________________________________________________________ NetChip Technology, Inc., 1999 335 Pioneer Way, Mountain View, California 94041 TEL (650) 526-1490 FAX (650) 526-1494 http://www.netchip.com Rev 2.0, Draft 9, July 16, 1999 16 LRESET# 32 O, 12mA, TP, PU Local Reset. This active low output is asserted when either the RESET# pin is asserted, or a USB upstream port reset is detected. This signal is not driven while the device is suspended, but will be pulled high by the internal pull-up resistor. WAKEUP# 34 I, PU Wakeup. This active low input causes the NET2890 to request a USB remote wakeup if device remote wakeup is enabled. BUSPWR# 22 I, S Bus Powered. This active low input indicates that the logic external to the NET2890 is powered by the USB bus. If this input is high, then the external logic is self-powered. This bit is readable by the local CPU through the MAINCTL configuration register. Alternatively, this bit can be used as a general input signal. PWRGOOD# 23 I, S Power Good. This active low input indicates that an external power supply used for self-powered mode is operational. This bit is readable by the local CPU through the MAINCTL configuration register. Alternatively, this bit can be used as a general input signal. SOF# 2 O, 12 mA, TP, PU Start of Frame. This signal pulses low for 8 USB full speed clocks when the Frame Timer is locked and an SOF token or synthesized SOF token is detected. TEST 30 I, PD Test. For normal operation, connect this pin to ground. TESTOUT 47 O, 12 mA Test Output. Used for manufacturing test. NC 29 -- No connect. VDD (USB, Core) 1, 13, 25, 37,43 Power Core Supply Voltage. Connect this pin to the +3.3V supply voltage to supply the core and the USB interface. VDD (Local) 31 Power Local Supply Voltage. Connect this pin to the +3.3V or +5.0V supply voltage to supply the local interface. VSS 12, 24, 36, 46, 48 GND Device Ground. Connect this pin to ground. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |