| 数据搜索系统,热门电子元器件搜索 |
|
CS5320 数据表(PDF) 78 Page - Applied Micro Circuits Corporation |
|
|
|||||||||||||||||||||||||||||
CS5320 数据表(HTML) 78 Page - Applied Micro Circuits Corporation |
|
78 / 160 page ![]() S5320 – PCI Match Maker: Operation Registers 78 DS1656 AMCC Confidential and Proprietary Revision 5.03 – June 14, 2006 Data Sheet The following describes one of the four configuration registers. All four region configuration registers are exactly the same. Table 37. Pass-thru Configuration Register Bit Description 7 PTADR# mode. This bit is only valid in Active mode. If this bit is 0, PTADR# is not driven at the beginning of a Active cycle. If this bit is set to 1 (default state), the S5320 will assert PTADR# for one clock cycle after PTATN# is asserted. The Pass-Thru address is also driven while PTADR# is low. This bit is a don’t care if the device is operating in Passive mode 6 Endian conversion. If this bit is set to one, the S5320 will convert the Add-On bus from the default little endian format to a big endian format. 5 Write FIFO disabled. If this bit is set to 1, the S5320 will not accept the next piece of data (on a PCI write) until the Add-On has accepted the previous piece of data. If this bit is set to 0, the S5320 will accept data from the PCI until the Pass-Thru write FIFO is full. 4:3 Prefetch. These bits control the number of DWORDs that the S5320 will prefetch after the current PCI Pass- Thru read completes. The actual amount of data prefetched depends upon any number of different scenarios. The prefetch values of “small”, “medium” and “large” are available to tune the system to achieve best overall performance (i.e. optimize PCI bus transfers or optimize Add-On bus transfers). The Pass-Thru read FIFO can be enabled to prefetch in either Active mode or Passive mode. 2:0 Wait states. In Active mode, the user can program the number of wait states required by the Add-On bus to com- plete a transaction. Up to 7 wait states can be programmed (per region). The S5320 will count the number of clocks programmed into this register before finishing the current data transaction if PTRDY# is high. If PTRDY# is driven low, additional wait states may be inserted. Bits 2, 1 and 0 are don’t care if operating in Passive mode. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |