MPC8540CPX667JC datasheet(39/104 Pages) FREESCALE

39 / 104 page

MPC8540 Integrated Processor Hardware Specifications, Rev. 4

Freescale Semiconductor

Local Bus

Figure 17 provides the AC test load for the local bus.

Figure 17. Local Bus AC Test Load

Local bus clock to output high impedance

for LAD/LDP

TSEC2_TXD[6:5] = 00

tLBKLOZ2

—0.2

TSEC2_TXD[6:5] = 11

(default)

1.5

Notes:

1.The symbols used for timing specifications herein follow the pattern of t(First two letters of functional block)(signal)(state) (reference)(state)

for inputs and t(First two letters of functional block)(reference)(state)(signal)(state) for outputs. For example, tLBIXKH1 symbolizes local

bus timing (LB) for the input (I) to go invalid (X) with respect to the time the tLBK clock reference (K) goes high (H), in this

case for clock one(1). Also, tLBKHOX symbolizes local bus timing (LB) for the tLBK clock reference (K) to go high (H), with

respect to the output (O) going invalid (X) or output hold time.

2.All timings are in reference to local bus clock for DLL bypass mode. Timings may be negative with respect to the local bus

clock because the actual launch and capture of signals is done with the internal launch/capture clock, which precedes

LCLK by tLBKHKT.

3.Maximum possible clock skew between a clock LCLK[m] and a relative clock LCLK[n]. Skew measured between

complementary signals at OVDD/2.

4.All signals are measured from OVDD/2 of the rising edge of local bus clock for DLL bypass mode to 0.4 × OVDD of the signal

in question for 3.3-V signaling levels.

5.Input timings are measured at the pin.

6.The value of tLBOTOT is defined as the sum of 1/2 or 1 ccb_clk cycle as programmed by LBCR[AHD], and the number of local

bus buffer delays used as programmed at power-on reset with configuration pins TSEC2_TXD[6:5].

7.For purposes of active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered

through the component pin is less than or equal to the leakage current specification.

8.Guaranteed by characterization.

9.Guaranteed by design.

Table 37. Local Bus General Timing Parameters—DLL Bypassed (continued)

Parameter

POR Configuration

Symbol 1

Min

Max

Unit

Notes

Output

OVDD/2

RL = 50 Ω

Z0 = 50 Ω

MPC8540CPX667JC 数据表(PDF) 39 Page - Freescale Semiconductor, Inc

MPC8540CPX667JC 数据表(HTML) 39 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载