MPC8540CPX667JC datasheet(89/104 Pages) FREESCALE

89 / 104 page

MPC8540 Integrated Processor Hardware Specifications, Rev. 4

Freescale Semiconductor

System Design Information

17 System Design Information

This section provides electrical and thermal design recommendations for successful application of the

MPC8540.

17.1 System Clocking

The MPC8540includes two PLLs.

1. The platform PLL generates the platform clock from the externally supplied SYSCLK input. The

frequency ratio between the platform and SYSCLK is selected using the platform PLL ratio

configuration bits as described in Section 15.2, “Platform/System PLL Ratio.”

2. The e500 Core PLL generates the core clock as a slave to the platform clock. The frequency ratio

between the e500 core clock and the platform clock is selected using the e500 PLL ratio

configuration bits as described in Section 15.3, “e500 Core PLL Ratio.”

17.2 PLL Power Supply Filtering

Each of the PLLs listed above is provided with power through independent power supply pins (AVDD1 and

AVDD2, respectively). The AVDD level should always be equivalent to VDD, and preferably these voltages

will be derived directly from VDD through a low frequency filter scheme such as the following.

There are a number of ways to reliably provide power to the PLLs, but the recommended solution is to

provide three independent filter circuits as illustrated in Figure 51, one to each of the three AVDD pins. By

providing independent filters to each PLL the opportunity to cause noise injection from one PLL to the

other is reduced.

This circuit is intended to filter noise in the PLLs resonant frequency range from a 500 kHz to 10 MHz

range. It should be built with surface mount capacitors with minimum Effective Series Inductance (ESL).

Consistent with the recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook

of Black Magic (Prentice Hall, 1993), multiple small capacitors of equal value are recommended over a

single large value capacitor.

Each circuit should be placed as close as possible to the specific AVDD pin being supplied to minimize

noise coupled from nearby circuits. It should be possible to route directly from the capacitors to the AVDD

pin, which is on the periphery of the 783 FC-PBGA footprint, without the inductance of vias.

Figure 51 shows the PLL power supply filter circuit.

Figure 51. PLL Power Supply Filter Circuit

VDD

AVDD (or L2AVDD)

2.2 µF

GND

Low ESL Surface Mount Capacitors

MPC8540CPX667JC 数据表(PDF) 89 Page - Freescale Semiconductor, Inc

MPC8540CPX667JC 数据表(HTML) 89 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载