H8SSLASH2218 datasheet(122/750 Pages) RENESAS

122 / 750 page

Section 3 MCU Operating Modes

Rev.6.00 Jun. 03, 2008 Page 74 of 698

REJ09B0074-0600

3.3

Operating Mode Descriptions

3.3.1

Mode 4 (Supported Only by the H8S/2218 Group)

The CPU can access a 16-Mbyte address space in advanced mode. The on-chip ROM is disabled.

Pins P13 to P10, and ports A, B, and C function as an address bus, ports D and E function as a data

bus, and part of port F carries bus control signals.

Pins P13 to P11 function as input ports immediately after a reset. Pin 10 and ports A and B

function as address (A20 to A8) outputs immediately after a reset. Address (A23 to A21) output

can be enabled or disabled by bits AE3 to AE0 in the pin function control register (PFCR)

regardless of the corresponding data direction register (DDR) values. Pins for which address

output is disabled among pins P13 to P10 and in ports A and B become port outputs when the

corresponding DDR bits are set to 1.

Port C always has an address (A7 to A0) output function.

The initial bus mode after a reset is 16 bits, with 16-bit access to all areas. However, note that if 8-

bit access is designated by the bus controller for all areas, the bus mode switches to 8 bits.

3.3.2

Mode 5 (Supported Only by the H8S/2218 Group)