H8SLASH3003 datasheet(533/715 Pages) RENESAS

533 / 715 page

17.4 Software Standby Mode

17.4.1 Transition to Software Standby Mode

To enter software standby mode, execute the SLEEP instruction while the SSBY bit is set to 1 in

SYSCR.

In software standby mode, current dissipation is reduced to an extremely low level because the

CPU, clock, and on-chip supporting modules all halt. The DMAC and on-chip supporting modules

are reset. As long as the specified voltage is supplied, however, CPU register contents and on-chip

RAM data are retained. The settings of the I/O ports and refresh controller* are also held.

Note: * The refresh timer counter (RTCNT) and bits 7 and 6 of the refresh timer control/status

17.4.2 Exit from Software Standby Mode

Software standby mode can be exited by input of an external interrupt at the NMI, IRQ0, IRQ1, or

IRQ2 pin, or by input at the RES or STBY pin.

Exit by Interrupt: When an NMI, IRQ0, IRQ1, or IRQ2 interrupt request signal is received, the

clock oscillator begins operating. After the oscillator settling time selected by bits STS2 to STS0

in SYSCR, stable clock signals are supplied to the entire H8/3003 chip, software standby mode

ends, and interrupt exception handling begins. Software standby mode is not exited if the interrupt

enable bits of interrupts IRQ0, IRQ1, and IRQ2 are cleared to 0, or if these interrupts are masked

in the CPU.

Exit by

RES Input: When the RES input goes low, the clock oscillator starts and clock pulses are

supplied immediately to the entire H8/3003 chip. The

RES signal must be held low long enough

for the clock oscillator to stabilize. When

RES goes high, the CPU starts reset exception handling.

Exit by

STBY Input: Low input at the STBY pin causes a transition to hardware standby mode.

515

H8/3003 数据表(PDF) 533 Page - Renesas Technology Corp