AM79C970A datasheet(45/219 Pages) AMD

45 / 219 page

P R E L I M I N A R Y

AMD

Am79C970A

The following figure shows a typical burst read access.

The PCnet-PCI II controller arbitrates for the bus, is

granted access, and reads three 32-bit words (DWord)

from the system memory and then releases the bus. In

the example, the memory system extends the data

phase of the each access by one wait state. The exam-

ple assumes that EXTREQ (BCR18, bit 8) is cleared to

ZERO, therefore,

REQ is deasserted in the same cycle

FRAME is asserted.

19436A-17

FRAME

CLK

IRDY

TRDY

DEVSEL

REQ

GNT

PAR

DEVSEL is sampled

ADDR

0000

0110

PAR

2345678

DATA

PAR

Figure 14. Burst Read Transfer (EXTREQ = 0, MEMCMD = 0)

Basic Non-Burst Write Transfer

By default, the PCnet-PCI II controller uses non-burst

cycles

all

bus

master

write

operations.

All

PCnet-PCI II controller non-burst write accesses are of

the PCI command type Memory Write (type 7). The

byte enable signals indicate the byte lanes that have

valid data.

The PCnet-PCI II controller typically performs more

than one non-burst write transactions within a single bus

mastership period.

FRAME is dropped between

consecutive non-burst write cycles.

REQ however stays

asserted until

FRAME is asserted for the last transac-

tion. The PCnet-PCI II controller supports zero wait

state write cycles except with the case of descriptor

write transfers. (See the section “Descriptor DMA

Transfers” for the only exception.) It asserts

IRDY im-

mediately after the address phase and at the same time

starts sampling

DEVSEL.

AM79C970A 数据表(PDF) 45 Page - Advanced Micro Devices

AM79C970A 数据表(HTML) 45 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载