AR0330_DS Rev. U Pub. 4/15 EN

75

©Semiconductor Components Industries, LLC,2015.

AR0330: 1/3-Inch CMOS Digital Image Sensor

Revision History

• Updated Table 10, “DC Electrical Definitions and Characteristics (HiSPi Mode),” on

page 18

• Updated Table 12, “Two-Wire Serial Interface Electrical Characteristics,” on page 20

• Updated Table 13, “Two-Wire Serial Interface Timing Specifications,” on page 20

• Updated Figure 8: “Two-Wire Serial Bus Timing Parameters,” on page 20

• Updated Table 16, “I/O Timing,” on page 22

• Updated Figure 17: “Relationship Between Readout Clock and Peak Pixel Rate,” on

page 32

• Updated Table 27, “PLL Parameters for the Serial Interface,” on page 35

• Updated Table 28, “Example PLL Configurations for the Serial Interface,” on page 35

• Added sentence to first paragraph under Figure 34: “Vertical Row Binning in the

AR0330 Sensor,” on page 49

• Updated Figure 39: “Example of the Slave Mode with a Flat-field Illumination,” on

page 57

Rev. J. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7/5/11

• Updated Table 10, “DC Electrical Definitions and Characteristics (HiSPi Mode),” on

page 18

Rev. H . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6/7/11

• Updated Figure 50: “CSP HiSPi Package,” on page 70

• Added Table 46, “CSP (MIPI/HiSPi) Package Dimensions,” on page 71

Rev.G . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5/26/11

• Updated Table 1, “Available Part Numbers,” on page 1

• Updated Table 1, “Key Parameters,” on page 1

• Updated Notes 8 and 10 in Figure 2: “Typical Configuration: Serial Four-Lane HiSPi

Interface,” on page 8

• Updated Notes 8 and 10 in Figure 3: “Typical Configuration: Serial MIPI,” on page 9

• Updated Notes 7 and 9 in Figure 4: “Typical Configuration: Parallel Pixel Data Inter-

face,” on page 10

Rev. F, Advance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/5/11

• Updated Figure 2: “Typical Configuration: Serial Four-Lane HiSPi Interface,” on

page 8

• Updated Table 6, “CSP (HiSPi/MIPI) Package Pinout,” on page 13

• Updated Figure 5: “CLCC Package Pin Descriptions,” on page 14

Rev. E, Advance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12/17/10

• Changed part number from AC0330 to AR0330

• Applied updated Aptina template

• Updated “Power-Up Sequence” on page 15

• Updated Figure 6: “Power Up,” on page 15

• Updated Table 27, “PLL Parameters for the Serial Interface,” on page 35

• Updated column 1 heading in Table 29, “Output Enable Control,” on page 36

• Updated Table 28, “Recommended Sensor Gain Tables,” on page 44

• Updated Figure 30: “Gain Stages in AR0330 Sensor,” on page 44

• Updated Figure 50: “CSP HiSPi Package,” on page 70

Rev. D, Advance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11/1/10

• Changed part number from MT9T002 to AC0330