AR0330 datasheet(11/77 Pages) ONSEMI

11 / 77 page

AR0330_DS Rev. U Pub. 4/15 EN

©Semiconductor Components Industries, LLC,2015.

AR0330: 1/3-Inch CMOS Digital Image Sensor

HiSPi Power Supply Connections

The HiSPi interface requires two power supplies. The VDD_HiSPi powers the digital logic

while the VDD_HiSPi _TX powers the output drivers. The digital logic supply is a nominal

1.8V and ranges from 1.7 to 1.9V. The HiSPi drivers can receive a supply voltage of 0.4 to

0.8V or 1.7 to 1.9V.

The common mode voltage is derived as half of the VDD_HiSPi _TX supply. Two settings

are available for the output common mode voltage:

1. SLVS mode. The VDD_HiSPi_Tx supply must be in the range of 0.4 to 0.8V and the

high_vcm register bit R0x306E[9] must be set to “0”. The output common mode volt-

age will be in the range of 0.2 to 0.4V.

2. HiVCM mode. The VDD_HiSPi_Tx supply must be in the range of 1.7 to 1.9V and the

high_vcm register bit R0x306E[9] must be set to “1”. The output common mode volt-

age will be in the range of 0.76 to 1.07V.

Two prior naming conventions have also been used with the VDD_HiSPi and

VDD_HiSPi _TX pins:

1. Digital logic supply was named VDD_SLVS while the driver supply was named

VDD_SLVS_TX.

2. Digital logic supply was named VDD_PHY while the driver supply was named

VDD_SLVS.

AR0330 数据表(PDF) 11 Page - ON Semiconductor