ST7MC1 datasheet(176/308 Pages) STMICROELECTRONICS

176 / 308 page

ST7MC1/ST7MC2

176/308

MOTOR CONTROLLER (Cont’d)

Figure 96. Simulated commutation event generation with only 1 Hall effect sensor (SC bit =1)

Note: If the SC bit is set during Z event interrupt,

then the 8*8 bit hardware multiplication result must

be overwritten in the MCOMP register. Otherwise,

when the SC bit is set, the result of the multiplica-

tion is not taken into account after a Z event.

Figure 97. Simulated commutation and Z event

C interrupt

SC set in MCRC

After C interrupt

MCOMP is written for Cs event

if MCOMP<=MTIM

Immediate CS generation

C interrupt

SC reset in MCRB

Next C event = CH with 8*8 bit multiplication

Z zero-crossing event

D Demagnetisation event

CH Hardware commutation

CS Simulated commutation

SC bit is reset

Z zero-crossing event

D Demagnetisation event

CH Hardware commutation

CS Simulated commutation

MCOMP

the result of the

hardware multiplication is put

in MCOMP-->CH and compared

SC bit is set during Z IT

the hardware multiplication is taken

into account but the value in MCOMP

can be overwritten

SC bit is already set when Z IT

occurs. The hardware multipli-

-cation is not taken into account

A value has to be written

in the MCOMP register

with MTIM once written

ST7MC1 数据表(PDF) 176 Page - STMicroelectronics

ST7MC1 数据表(HTML) 176 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载