ST7MC1 datasheet(177/308 Pages) STMICROELECTRONICS

177 / 308 page

ST7MC1/ST7MC2

177/308

MOTOR CONTROLLER (Cont’d)

The Figure 98 gives the step ratio register value

(left axis) and the number of BEMF sampling dur-

ing one electrical step with the corresponding ac-

curacy on the measure (right axis) as a function of

the mechanical frequency.

For a given prescaler value (step ratio register) the

mechanical frequency can vary between two fixed

values shown on the graph as the segment ends.

In autoswitched mode, this register is automatical-

ly incremented/decremented when the step fre-

quency goes out of this segment.

At fMTC=4MHz, the range covered by the Step Ra-

tio mechanism goes from 2.39 to 235000 (pole

pair x rpm) with a minimum accuracy of 1.2% on

the step period.

To read the number of samples for Zn within one

step (right Y axis), select the mechanical frequen-

cy on the X axis and the sampling frequency curve

used for BEMF detection (PWM frequency or

measurement window frequency). For example,

for N.Frpm = 15,000 and a sampling frequency of

15kHz, there are approximately 10 samples in one

step and there is a 10% error rate on the measure-

ment.

Figure 98. Step Ratio Bits decoding and accuracy results and BEMF Sampling Rate

Step Ratio (Decimal)

N.Frpm

avg Zn ~ 7Fh ± 0.6%

100%

BEMF

samples

∆Zn/Zn

10%

50%

200 Hz

15 kHz

avg Zn ~ FFh ± 0.4%

avg Zn ~ 7Fh ± 0.6%

avg Zn ~ FFh ± 0.4%

avg Zn ~ 55h ± 1.2%

3.Fn

Fn+1 = 2.Fn

3.Fn+1 = 6.Fn

Fstep = 6.N.Frpm = N.F / 10 ⇔ N.F = 10.Fstep

N: Pole pair number

Fstep: Electrical step frequency

ST[3:0]

avg Zn ~ 55h ± 1.2%

ST7MC1 数据表(PDF) 177 Page - STMicroelectronics

ST7MC1 数据表(HTML) 177 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载