LPC2917 datasheet(37/68 Pages) PHILIPS

37 / 68 page

LPC2917_19_1

Preliminary data sheet

Rev. 1.01 — 15 November 2007

37 of 68

NXP Semiconductors

LPC2917/19

ARM9 microcontroller with CAN and LIN

8.7.5.4

ADC clock description

The ADC modules are clocked from two different sources; CLK_MSCSS_ADCx_VPB and

CLK_ADCx (x = 1 or 2), see Section 7.2.2. Note that each ADC has its own CLK_ADCx

and CLK_MSCSS_ADCx_VPB branch clocks for power management. If an ADC is

unused both its CLK_MSCSS_ADCx_VPB and CLK_ADCx can be switched off.

The frequency of all the CLK_MSCSS_ADCx_VPB clocks is identical to

CLK_MSCSS_VPB since they are derived from the same base clock

BASE_MSCSS_CLK. Likewise the frequency of all the CLK_ADCx clocks is identical

since they are derived from the same base clock BASE_ADC_CLK.

The register interface towards the system bus is clocked by CLK_MSCSS_ADCx_VPB.

Control logic for the analog section of the ADC is clocked by CLK_ADCx, see also

Figure 9.

8.7.6 PWM

8.7.6.1

Overview

The MSCSS in the LPC2917/19 includes four PWM modules with the following features.

• Six pulse-width modulated output signals

• Double edge features (rising and falling edges programmed individually)

• Optional interrupt generation on match (each edge)

• Different operation modes: continuous or run-once

• 16-bit PWM counter and 16-bit prescale counter allow a large range of PWM periods

• A protective mode (TRAP) holding the output in a software-controllable state and with

optional interrupt generation on a trap event

• Three capture registers and capture trigger pins with optional interrupt generation on

a capture event

• Interrupt generation on match event, capture event, PWM counter overflow or trap

event

• A burst mode mixing the external carrier signal with internally generated PWM

• Programmable sync-delay output to trigger other PWM modules (master/slave

behavior)

8.7.6.2

Description

The ability to provide flexible waveforms allows PWM blocks to be used in multiple

applications; e.g. automotive dimmer/lamp control and fan control. Pulse-width

modulation is the preferred method for regulating power since no additional heat is

generated and it is energy-efficient when compared with linear-regulating voltage control

networks.

The PWM delivers the waveforms/pulses of the desired duty cycles and cycle periods. A

very basic application of these pulses can be in controlling the amount of power

transferred to a load. Since the duty cycle of the pulses can be controlled, the desired

amount of power can be transferred for a controlled duration. Two examples of such

applications are:

LPC2917 数据表(PDF) 37 Page - NXP Semiconductors

LPC2917 数据表(HTML) 37 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

数据表下载