H8SSLASH2225 datasheet(620/1071 Pages) RENESAS

620 / 1071 page

Section 14 IEBus™ Controller (IEB) [H8S/2258 Group]

Rev. 5.00 Aug 08, 2006 page 534 of 982

REJ09B0054-0500

Specify the communications destination slave unit address.

(d) Setting the IEBus Master Control Register (IEMCR)

Select broadcast/normal communications, specify the number of retransfer counts at arbitration

loss, and specify the control bits.

(e) Setting the IEBus Receive Interrupt Enable Register (IEIER)

Enable the RxRDY (IERxI), RxS, RxF, and RxE (IERSI) interrupts.

The above registers can be specified in any order. (The register specification order does not affect

the IEB operation.)

(2) DTC Initialization

1. Set the start address of the RAM which stores the register information necessary for the DTC

transfer in the vector address (H'000004D2) to be accessed when a DTC transfer request is

generated.

2. Set the following data from the start address of the RAM.

 Transfer source address (SAR): Address (H'FFF80D) of the IEBus receive buffer register

(IERBR).

 Transfer destination address (DAR): Start address of the RAM which stores data to be

received from the data field.

 Transfer count (CRA): Maximum number of transfer bytes in one frame in the transfer

mode.

3. Set bit DTCEG6 in the DTC enabler register G (DTCERG), and enable the RxRDY interrupt

(IERxI).

Because the above settings are performed before frame reception, the length of data to be received

cannot be determined. Accordingly, the maximum number of transfer bytes in one frame is

specified as the DTC transfer count.

If the DTC is specified after reception starts, the above settings are performed in the receive start

detection (RxS) interrupt handling routine. In this case, the transfer count must be the same value

as the contents of the IEBus receive message length register (IERBFL).

H8S/2225 数据表(PDF) 620 Page - Renesas Technology Corp