H8SSLASH2225 datasheet(623/1071 Pages) RENESAS

623 / 1071 page

Section 14 IEBus™ Controller (IEB) [H8S/2258 Group]

Rev. 5.00 Aug 08, 2006 page 537 of 982

REJ09B0054-0500

Specify the message length bits.

(d) Setting the IEBus Transmit/Runaway Interrupt Enable Register (IEIET)

Enable the TxRDY (IETxI), TxS, and TxE (IETSI) interrupts.

The above registers can be specified in any order. (The register specification order does not affect

the IEB operation.)

(2) DTC Initialization

1. Set the start address of the RAM which stores the register information necessary for the DTC

transfer in the vector address (H'000004D4) to be accessed a DTC transfer request is

generated.

2. Set the following data from the start address of the RAM.

 Transfer source address (SAR): Start address of the RAM which stores data to be

transmitted from the data field.

 Transfer destination address (DAR): Address (H'FFF808) of the IEBus transmit buffer

 Transfer count (CRA): The same value as IETBFL

3. Set bit DTCEG5 in the DTC enabler register G (DTCERG), and enable the TxRDY interrupt

(IETxI).

Because the TxRDY flag is retained after reset, the DTC transfer is executed when the IETxI is

enabled and the first data field data is written to IETBR. The DTC negates the TxRDY flag

and the DTC transfer of the first byte is completed.

(3) Slave Transmission Flow

Figure 14.12 shows the slave transmission flow. Numbers in the following description correspond

to the numbers in Figure 14.12.

1. After the IEB and DTC have been initialized, a slave communications request command is

issued from IECMR. During slave reception, the command execution status flag (CMX) in

IEFLG is set and the slave communications request will not be issued.

2. The CMX flag is cleared when the slave reception is completed, the slave communications

command is executed, and the SRQ flag is set.

3. If data up to the control field has been received correctly and if the contents of the control bits

is H'3 or H'7, the transmit start detection flag (TxS) in IETSR register is set to 1. In this case,

the TxS flag is cleared in the TxS interrupt handling routine.

4. The slave then transmits the message length field, and the IEB loads the transmit data in the

data field from IETBR when the ACK is received. Then the TxRDY flag is set to 1. A DTC

H8S/2225 数据表(PDF) 623 Page - Renesas Technology Corp

H8S/2225 数据表(HTML) 623 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载