ST92F120JR9T datasheet(195/320 Pages) STMICROELECTRONICS

195 / 320 page

195/320

SERIAL COMMUNICATIONS INTERFACE (SCI)

SERIAL COMMUNICATIONS INTERFACE (Cont’d)

10.5.9 Interrupts and DMA

10.5.9.1 Interrupts

The SCI can generate interrupts as a result of sev-

eral conditions. Receiver interrupts include data

pending, receive errors (overrun, framing and par-

ity), as well as address or break pending. Trans-

mitter interrupts are software selectable for either

Transmit Buffer Register Empty (BSN set) or for

Transmit Shift Register Empty (BSN reset) condi-

tions.

Typical usage of the Interrupts generated by the

SCI peripheral are illustrated in Figure 98.

The SCI peripheral is able to generate interrupt re-

quests as a result of a number of events, several

of which share the same interrupt vector. It is

therefore necessary to poll S_ISR, the Interrupt

Status Register, in order to determine the active

trigger. These bits should be reset by the program-

mer during the Interrupt Service routine.

The four major levels of interrupt are encoded in

hardware to provide two bits of the interrupt vector

er vectors to be resolved to an 8 byte block size.

The SCI interrupts have an internal priority struc-

ture in order to resolve simultaneous events. Refer

also to Section 10.5.3 SCI Operating Modes for

more details relating to Synchronous mode.

Table 39. SCI Interrupt Internal Priority

Receive DMA Request

Highest Priority

Transmit DMA Request

Receive Interrupt

Transmit Interrupt

Lowest Priority

ST92F120JR9T 数据表(PDF) 195 Page - STMicroelectronics

ST92F120JR9T 数据表(HTML) 195 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载