| 数据搜索系统,热门电子元器件搜索 |
|
MPC8640DEC 数据表(PDF) 68 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
MPC8640DEC 数据表(HTML) 68 Page - Freescale Semiconductor, Inc |
|
68 / 140 page ![]() MPC8640 and MPC8640D Integrated Host Processor Hardware Specifications, Rev. 1 68 Freescale Semiconductor High-Speed Serial Interfaces (HSSI) Figure 47. Differential Measurement Points for Rise and Fall Time Figure 48. Single-Ended Measurement Points for Rise and Fall Time Matching The other detailed AC requirements of the SerDes Reference Clocks is defined by each interface protocol based on application usage. Refer to the following sections for detailed information: • Section 14.2, “AC Requirements for PCI Express SerDes Clocks” • Section 15.2, “AC Requirements for Serial RapidIO SDn_REF_CLK and SDn_REF_CLK Rising edge rate (SD n_REF_CLK) to falling edge rate (SD n_REF_CLK) matching Rise-Fall Matching —20 % 1, 4 Notes: 1. Measurment taken from single ended waveform. 2. Measurment taken from differential waveform. 3. Measured from -200 mV to +200 mV on the differential waveform (derived from SD n_REF_CLK minus SDn_REF_CLK). The signal must be monotonic through the measurement region for rise and fall time. The 400 mV measurement window is centered on the differential zero crossing. See Figure 47. 4. Matching applies to rising edge rate for SD n_REF_CLK and falling edge rate for SDn_REF_CLK. It is measured using a 200 mV window centered on the median cross point where SDn_REF_CLK rising meets SD n_REF_CLK falling. The median cross point is used to calculate the voltage thresholds the oscilloscope is to use for the edge rate calculations. The Rise Edge Rate of SD n_REF_CLK should be compared to the Fall Edge Rate of SDn_REF_CLK, the maximum allowed difference should not exceed 20% of the slowest edge rate. See Figure 48. Table 46. SerDes Reference Clock Common AC Parameters (continued) At recommended operating conditions with XVDD_SRDS1 or XVDD_SRDS2 = 1.1V ± 5% and 1.05V ± 5%. Parameter Symbol Min Max Unit Notes VIH = +200 mV VIL = -200 mV 0.0 V SD n_REF_CLK minus SD n_REF_CLK SD n_REF_CLK SD n_REF_CLK SD n_REF_CLK SD n_REF_CLK |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |