ST7263BEx datasheet(64/186 Pages) STMICROELECTRONICS

64 / 186 page

On-chip peripherals

ST7263Bxx

64/186

Doc ID 7516 Rev 8

Note:

After reading the ICiHR register, transfer of input capture data is inhibited and ICFi will never

be set until the ICiLR register is also read.

The ICiR register contains the free running counter value which corresponds to the most

recent input capture.

The two input capture functions can be used together even if the timer also uses the two

output compare functions.

In One Pulse mode and PWM mode only input Capture 2 can be used.

The alternate inputs (ICAP1 and ICAP2) are always directly connected to the timer. So any

transitions on these pins activates the input capture function.

Moreover if one of the ICAPi pins is configured as an input and the second one as an output,

an interrupt can be generated if the user toggles the output pin and if the ICIE bit is set.

This can be avoided if the input capture function i is disabled by reading the ICiHR (see note

1).

The TOF bit can be used with interrupt generation in order to measure events that go

beyond the timer range (FFFFh).

Figure 32.

Input Capture block diagram

Figure 33.

Input Capture timing diagram

The rising edge is the active edge.

ICIE

CC0

CC1

16-BIT FREE RUNNING

COUNTER

IEDG1

(Control register 1) CR1

(Control register 2) CR2

ICF2

ICF1

(Status register) SR

IEDG2

ICAP1

ICAP2

EDGE DETECT

CIRCUIT2

16-BIT

IC1R register

IC2R register

EDGE DETECT

CIRCUIT1

FF01

FF02

FF03

TIMER CLOCK

COUNTER REGISTER

ICAPi PIN

ICAPi FLAG

ICAPi REGISTER

ST7263BEx 数据表(PDF) 64 Page - STMicroelectronics

ST7263BEx 数据表(HTML) 64 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载