ADE5166 datasheet(54/156 Pages) AD

54 / 156 page

ADE5166/ADE5169/ADE5566/ADE5569

Rev. B | Page 54 of 156

Figure 56 shows the mechanism of the zero-crossing timeout

detection when the line voltage stays at a fixed dc level for more

than MCLK/160 × ZXTOUT seconds.

12-BIT INTERNAL

ZXTOUT

ZXTO

FLAG

BIT

VOLTAGE

CHANNEL

Figure 56. Zero-Crossing Timeout Detection

Period or Frequency Measurements

The ADE5166/ADE5169/ADE5566/ADE5569 provide the period

or frequency measurement of the line. The period or frequency

measurement is selected by clearing or setting the FREQSEL bit

(Bit 1) in the MODE2 register (Address 0x0C). The period/

frequency register, PER_FREQ (Address 0x0A), is an unsigned

16-bit register that is updated every period. If LPF1 is enabled,

a settling time of 1.8 sec is associated with this filter before the

measurement is stable.

When the period measurement is selected, the measurement has a

2.44 μs/LSB (4.096 MHz/10) resolution, which represents 0.014%

when the line frequency is 60 Hz. When the line frequency is

60 Hz, the value of the period register is approximately 0d6827.

The length of the register enables the measurement of line fre-

quencies as low as 12.5 Hz. The period register is stable at ±1 LSB

when the line is established and the measurement does not change.

When the frequency measurement is selected, the measurement

has a 0.0625 Hz/LSB resolution when MCLK = 4.096 MHz, which

represents 0.104% when the line frequency is 60 Hz. When the

line frequency is 60 Hz, the value of the frequency register is 0d960.

The frequency register is stable at ±4 LSB when the line is estab-

lished and the measurement does not change.

Line Voltage SAG Detection

In addition to detection of the loss of the line voltage signal

(zero crossing), the ADE5166/ADE5169/ADE5566/ADE5569 can

also be programmed to detect when the absolute value of the line

voltage drops below a certain peak value for a number of line

cycles. This condition is illustrated in Figure 57.

SAG IS RESET LOW

WHEN VOLTAGE

CHANNEL EXCEEDS

SAGLVL[15:0] AND

SAG FLAG IS RESET

FULL SCALE

SAGLVL[15:0]

SAG FLAG

SAGCYC[7:0] = 0x04

3 LINE CYCLES

VOLTAGE CHANNEL

Figure 57. SAG Detection

Figure 57 shows the line voltage falling below a threshold that

is set in the SAG level register (SAGLVL, Address 0x14[15:0])

for three line cycles. The quantities 0 and 1 are not valid for the

SAGCYC register, and the contents represent one more than the

desired number of full line cycles. For example, when the SAG

cycle register (SAGCYC, Address 0x13[7:0]) contains 0x04, FSAG

(Bit 5) in the power management interrupt flag SFR (IPSMF,

Address 0xF8) is set at the end of the third line cycle after the line

voltage falls below the threshold. If the SAG enable bit (ESAG,

Bit 5) in the power management interrupt enable SFR (IPSME,

Address 0xEC) is set, the 8052 core has a pending power supply

management interrupt. The PSM interrupt stays active until the

ESAG bit is cleared (see the Power Supply Management (PSM)

Interrupt section).

In Figure 57, the SAG flag (FSAG) is set on the fifth line cycle

after the signal on the voltage channel first drops below the

threshold level.

SAG Level Set

The 2-byte contents of the SAG level register (SAGLVL,

Address 0x14) are compared to the absolute value of the output

from LPF1. Therefore, when LPF1 is enabled, writing 0x2038 to the

SAG level register puts the SAG detection level at full scale (see

Figure 57). Writing 0x00 or 0x01 puts the SAG detection level

at 0. The SAG level register is compared to the input of the ZX

detection, and detection is made when the ZX input falls below the

contents of the SAG level register.

ADE5166 数据表(PDF) 54 Page - Analog Devices

ADE5166 数据表(HTML) 54 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载