ADE5166 datasheet(96/156 Pages) AD

96 / 156 page

ADE5166/ADE5169/ADE5566/ADE5569

Rev. B | Page 96 of 156

INTERRUPT VECTORS

When an interrupt occurs, the program counter is pushed onto the

stack, and the corresponding interrupt vector address is loaded

into the program counter. When the interrupt service routine is

complete, the program counter is popped off the stack by a RETI

instruction. This allows program execution to resume from where

it was interrupted. The interrupt vector addresses are shown in

Table 87.

Table 87. Interrupt Vector Addresses

Source

Vector Address

IE0

0x0003

TF0

0x000B

IE1

0x0013

TF1

0x001B

RI + TI

0x0023

TF2 + EXF2

0x002B

ITEMP (Temperature ADC)

0x0033

ISPI/I2CI

0x003B

IPSM (Power Supply)

0x0043

IADE (Energy Measurement DSP)

0x004B

IRTC (RTC Interval Timer)

0x0053

WDT (Watchdog Timer)

0x005B

RI2 + TI2

0x0063

INTERRUPT LATENCY

The 8052 architecture requires that at least one instruction

execute between interrupts. To ensure this, the 8052 MCU

core hardware prevents the program counter from jumping to

an interrupt service routine (ISR) immediately after completing

a RETI instruction or an access of the IP and IE SFRs.

The shortest interrupt latency is 3.25 instruction cycles, 800 ns

with a clock of 4.096 MHz. The longest interrupt latency for a

high priority interrupt results when a pending interrupt is gen-

erated during a low priority interrupt RETI, followed by a multiply

instruction. This results in a maximum interrupt latency of 16.25

instruction cycles, 4 μs with a clock of 4.096 MHz.

CONTEXT SAVING

When the 8052 vectors to an interrupt, only the program counter

is saved on the stack. Therefore, the interrupt service routine must

be written to ensure that registers used in the main program are

restored to their pre-interrupt state. Common SFRs that can be

modified in the ISR are the accumulator register and the PSW

pads in the ISR should also be restored before exiting the

interrupt. The following example 8052 code shows how to

restore some commonly used registers:

GeneralISR:

; save the current accumulator value

PUSH

ACC

; save the current status and register bank

selection

PUSH

PSW

; service interrupt

…

; restore the status and register bank

selection

POP

PSW

; restore the accumulator

POP

ACC

RETI

ADE5166 数据表(PDF) 96 Page - Analog Devices

ADE5166 数据表(HTML) 96 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载