EM357-RTR datasheet(178/240 Pages) ETC2

178 / 240 page

EM351 / EM357

Reset initializes the offset to zero (ADC_OFFSET = 0) and gain factor to one (ADC_GAIN = 0x8000).

10.1.4 DMA

The ADC DMA channel writes converted data, which incorporates the offset/gain correction, into a DMA buffer

in RAM.

The ADC DMA buffer is defined by two registers:

ADC_DMABEG is the start address of the buffer and must be even.

ADC_DMASIZE specifies the size of the buffer in 16-bit samples, or half its length in bytes.

To prepare the DMA channel for operation, reset it by writing the ADC_DMARST bit in the ADC_DMACFG

ADC_DMACFG register. The ADC_DMAAUTOWRAP bit in the ADC_DMACFG register selects the DMA mode: 0 for

linear mode, 1 for auto wrap mode.

In linear mode the DMA writes to the buffer until the number of samples given by ADC_DMASIZE has been

output. The DMA then stops and sets the INT_ADCULDFULL bit in the INT_ADCFLAG register. If another ADC

conversion completes before the DMA is reset or the ADC is disabled, the INT_ADCOVF bit in the

INT_ADCFLAG register is set.

In auto wrap mode the DMA writes to the buffer until it reaches the end, then resets its pointer to the

start of the buffer and continues writing samples. The DMA transfers continue until the ADC is disabled or

the DMA is reset.

When the DMA fills the lower and upper halves of the buffer, it sets the INT_ADCULDHALF and

INT_ADCULDFULL bits, respectively, in the INT_ADCFLAG register. The current location to which the DMA is

writing can also be determined by reading the ADC_DMACUR register.

10.1.5 ADC Configuration Register

The ADC configuration register (ADC_CFG) sets up most of the ADC operating parameters.

10.1.5.1 Input

The analog input of the ADC can be chosen from various sources. The analog input is configured with the

ADC_MUXP and ADC_MUXN bits within the ADC_CFG register. Table 10-2 shows the possible input selections.

10-3

120-035X-000D

Preliminary

EM357-RTR 数据表(PDF) 178 Page - List of Unclassifed Manufacturers