| 数据搜索系统,热门电子元器件搜索 |
|
PPC8567CVTAQGGA 数据表(PDF) 13 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
PPC8567CVTAQGGA 数据表(HTML) 13 Page - Freescale Semiconductor, Inc |
|
13 / 139 page ![]() MPC8568E/MPC8567E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 1 Freescale Semiconductor 13 Electrical Characteristics The core voltage must always be provided at nominal 1.1V. (See Table 3 for actual recommended core voltage). Voltage to the processor interface I/Os are provided through separate sets of supply pins and must be provided at the voltages shown in Table 3. The input voltage threshold scales with respect to the associated I/O supply voltage. OVDD and LVDD based receivers are simple CMOS I/O circuits and satisfy appropriate LVCMOS type specifications. The DDR SDRAM interface uses a single-ended differential receiver referenced the externally supplied MVREF signal (nominally set to GVDD/2) as is appropriate for the SSTL2 electrical signaling standard. 2.1.3 Output Driver Characteristics Table 4 provides information on the characteristics of the output driver strengths. The values are preliminary estimates. 2.2 Power Sequencing The MPC8568E requires its power rails to be applied in specific sequence in order to ensure proper device operation. These requirements are as follows for power up: 1. VDD, AVDD_n, BVDD, SCOREVDD, LVDD, TVDD, XVDD, OVDD 2. GVDD All supplies must be at their stable values within 50 ms. Table 4. Output Drive Capability Driver Type Programmable Output Impedance ( Ω) Supply Voltage Notes Local bus interface utilities signals 25 25 BVDD = 3.3 V BVDD = 2.5 V 1 45(default) 45(default) BVDD = 3.3 V BVDD = 2.5 V PCI signals 25 OVDD = 3.3 V 2 42 (default) DDR signal 20 GVDD = 2.5 V — DDR2 signal 16 32 (half strength mode) GVDD = 1.8 V — eTSEC 10/100/1000 signals 42 L/TVDD = 2.5/3.3 V — DUART, system control, JTAG 42 OVDD = 3.3 V — I2C 150 OVDD = 3.3 V — Notes: 1. The drive strength of the local bus interface is determined by the configuration of the appropriate bits in PORIMPSCR. 2. The drive strength of the PCI interface is determined by the setting of the PCI_GNT[1] signal at reset. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |