ADE5166 datasheet(127/156 Pages) AD

127 / 156 page

ADE5166/ADE5169/ADE5566/ADE5569

Rev. B | Page 127 of 156

UART SERIAL INTERFACE

The ADE5166/ADE5169/ADE5566/ADE5569 UART can be

configured in one of four modes.

•

Shift register with baud rate fixed at fCORE/12

•

8-bit UART with variable baud rate

•

9-bit UART with baud rate fixed at fCORE/64 or fCORE/32

•

9-bit UART with variable baud rate

Variable baud rates are defined by using an internal timer to

generate any rate between 300 bauds/sec and 115,200 bauds/sec.

The UART serial interface provided in the ADE5166/ADE5169/

ADE5566/ADE5569 is a full-duplex serial interface. It is also

receive buffered by storing the first received byte in a receive buffer

until the reception of the second byte is complete. The physical

interface to the UART is provided via the RxD (P1.0/RxD) and

TxD (P1.1/TxD) pins, and the firmware interface is through the

SFRs, as presented in Table 139.

Both the serial port receive and transmit registers are accessed

through the serial port buffer SFR (SBUF, Address 0x99). Writing

to SBUF loads the transmit register, and reading SBUF accesses

a physically separate receive register.

An enhanced UART mode is offered by using the UART timer and

by providing enhanced frame error, break error, and overwrite

error detection. This mode is enabled by setting the EXTEN bit

in the configuration SFR (CFG, Address 0xAF[6]) (see the UART

Additional Features section). The enhanced serial baud rate control

SFR (SBAUDT, Address 0x9E) and UART timer fractional divider

SFR (SBAUDF, Address 0x9D) are used to configure the UART

timer and to indicate the enhanced UART errors.

UART SFRs

Table 139. Serial Port SFRs

SFR

Address

Bit Addressable

Description

SCON

0x98

Yes

Serial communications control (see Table 140).

SBUF

0x99

Serial port buffer (see Table 141).

SBAUDT

0x9E

Enhanced serial baud rate control (see Table 142).

SBAUDF

0x9D

UART timer fractional divider (see Table 143).

Table 140. Serial Communications Control SFR (SCON, Address 0x98)

Bit

Bit Address

Mnemonic

Default

Description

[7:6]

0x9F, 0x9E

SM0, SM1

UART serial mode select bits. These bits select the serial port operating mode.

SM0, SM1

Result (Selected Operating Mode)

Mode 0, shift register, fixed baud rate (fCORE/12)

Mode 1, 8-bit UART, variable baud rate

Mode 2, 9-bit UART, fixed baud rate (fCORE/32) or (fCORE/16)

Mode 3, 9-bit UART, variable baud rate

0x9D

SM2

Multiprocessor communication enable bit. Enables multiprocessor communication in

Mode 2 and Mode 3, and framing error detection in Mode 1.

In Mode 0, SM2 should be cleared.

In Mode 1, if SM2 is set, RI is not activated if a valid stop bit was not received.

If SM2 is cleared, RI is set as soon as the byte of data is received.

In Mode 2 or Mode 3, if SM2 is set, RI is not activated if the received ninth data bit in RB8 is 0.

If SM2 is cleared, RI is set as soon as the byte of data is received.

0x9C

REN

Serial port receive enable bit. Set by user software to enable serial port reception.

Cleared by user software to disable serial port reception.

0x9B

TB8

Serial port transmit (Bit 9). The data loaded into TB8 is the ninth data bit transmitted in

Mode 2 and Mode 3.

0x9A

RB8

Serial port receiver (Bit 9). The ninth data bit received in Mode 2 and Mode 3 is latched

into RB8. For Mode 1, the stop bit is latched into RB8.

0x99

Serial port transmit interrupt flag. Set by hardware at the end of the eighth bit in Mode 0 or

at the beginning of the stop bit in Mode 1, Mode 2, and Mode 3.

TI must be cleared by user software.

0x98

Serial port receive interrupt flag. Set by hardware at the end of the eighth bit in Mode 0 or

halfway through the stop bit in Mode 1, Mode 2, and Mode 3.

RI must be cleared by user software.

ADE5166 数据表(PDF) 127 Page - Analog Devices

ADE5166 数据表(HTML) 127 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载