CYWUSB6953_10 datasheet(47/68 Pages) CYPRESS

47 / 68 page

CYRF69103

Document #: 001-07611 Rev *F

Page 47 of 68

19.7 SPI Interface Pins

The SPI interface between the radio function and MCU function

uses pins P1.3–P1.5 and optionally P1.6. These pins are

configured using the P1.3 and P1.4–P1.6 Configuration.

20. Timer Registers

All timer functions of the CYRF69103 are provided by a single

timer block. The timer block is asynchronous from the CPU clock.

The 16-bit free running counter is used as the time-base for timer

captures and can also be used as a general time-base by

software.

20.1 Registers

20.1.1 Free Running Counter

The 16-bit free running counter is clocked by a 4 or 6 MHz

source. It can be read in software for use as a general purpose

time base. When the low order byte is read, the high order byte

is registered. Reading the high order byte reads this register

allowing the CPU to read the 16-bit value atomically (loads all

bits at one time). The free running timer generates an interrupt

at 1024

μs rate. It can also generate an interrupt when the free

running counter overflow occurs—every 16.384 ms. This allows

extending the length of the timer in software.

Figure 20-1. 16-bit Free Running Counter Block Diagram

Table 19-17. SPI SCLK Frequency

SCLK

Select

CPUCLK

Divisor

SCLK Frequency when

CPUCLK = 12 MHz

2 MHz

1 MHz

250 kHz

125 kHz

Timer Capture

Clock

16-bit Free

Running Counter

Overflow

Interrupt

1024-µs

Timer

Interrupt

Table 20-1. Free Running Timer Low Order Byte (FRTMRL) [0x20] [R/W]

Bit #

Field

Free Running Timer [7:0]

Read/Write

R/W

Default

Bits 7:0

Free running Timer [7:0]

This register holds the low order byte of the 16-bit free running timer. Reading this register causes the high order byte to be

moved into a holding register allowing an automatic read of all 16 bits simultaneously.

For reads, the actual read occurs in the cycle when the low order is read. For writes the actual time the write occurs is the cycle

when the high order is written.

When reading the free running timer, the low order byte must be read first and the high order second. When writing, the low

order byte must be written first then the high order byte.

[+] Feedback

CYWUSB6953 数据表(PDF) 47 Page - Cypress Semiconductor

CYWUSB6953 数据表(HTML) 47 Page - Cypress Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

数据表下载