TMP86FS49AIUG datasheet(39/296 Pages) TOSHIBA

39 / 296 page

Page 23

TMP86FS49AIUG

• Start the IDLE1/2 and SLEEP1/2 modes

After IMF is set to "0", set the individual interrupt enable flag (EF) which releases IDLE1/2

and SLEEP1/2 modes. To start IDLE1/2 and SLEEP1/2 modes, set SYSCR2<IDLE> to “1”.

• Release the IDLE1/2 and SLEEP1/2 modes

IDLE1/2 and SLEEP1/2 modes include a normal release mode and an interrupt release mode.

These modes are selected by interrupt master enable flag (IMF). After releasing IDLE1/2 and

SLEEP1/2 modes, the SYSCR2<IDLE> is automatically cleared to “0” and the operation mode

is returned to the mode preceding IDLE1/2 and SLEEP1/2 modes.

IDLE1/2 and SLEEP1/2 modes can also be released by inputting low level on the RESET pin.

After releasing reset, the operation mode is started from NORMAL1 mode.

(1)

Normal release mode (IMF = “0”)

IDLE1/2 and SLEEP1/2 modes are released by any interrupt source enabled by the individual

interrupt enable flag (EF). After the interrupt is generated, the program operation is resumed from the

instruction following the IDLE1/2 and SLEEP1/2 modes start instruction. Normally, the interrupt

latches (IL) of the interrupt source used for releasing must be cleared to “0” by load instructions.

(2)

Interrupt release mode (IMF = “1”)

IDLE1/2 and SLEEP1/2 modes are released by any interrupt source enabled with the individual

interrupt enable flag (EF) and the interrupt processing is started. After the interrupt is processed, the

program operation is resumed from the instruction following the instruction, which starts IDLE1/2

and SLEEP1/2 modes.

Note: When a watchdog timer interrupts is generated immediately before IDLE1/2 and SLEEP1/2

modes are started, the watchdog timer interrupt will be processed but IDLE1/2 and SLEEP1/2

modes will not be started.

TMP86FS49AIUG 数据表(PDF) 39 Page - Toshiba Semiconductor