TMP86FS49AIUG datasheet(45/296 Pages) TOSHIBA

45 / 296 page

Page 29

TMP86FS49AIUG

(2)

Switching from SLOW1 mode to NORMAL2 mode

Note: After SYSCK is cleared to “0”, executing the instructions is continiued by the low-frequency clock

for the period synchronized with low-frequency and high-frequency clocks.

First, set SYSCR2<XEN> to turn on the high-frequency oscillation. When time for stabilization

(Warm up) has been taken by the timer/counter (TC6,TC5), clear SYSCR2<SYSCK> to switch the

main system clock to the high-frequency clock.

SLOW mode can also be released by inputting low level on the RESET pin. After releasing reset, the

operation mode is started from NORMAL1 mode.

Example :Switching from the SLOW1 mode to the NORMAL2 mode (fc = 16 MHz, warm-up time is 4.0 ms).

SET

(SYSCR2). 7

; SYSCR2<XEN>

← 1 (Starts high-frequency oscillation)

(TC5CR), 63H

; Sets mode for TC6, 5 (16-bit mode, fc for source)

(TC6CR), 05H

; Sets warming-up counter mode

(TTREG6), 0F8H

; Sets warm-up time

; IMF

← 0

SET

(EIRE). 2

; Enables INTTC6

; IMF

← 1

SET

(TC6CR). 3

; Starts TC6, 5

PINTTC6:

CLR

(TC6CR). 3

; Stops TC6, 5

CLR

(SYSCR2). 5

; SYSCR2<SYSCK>

← 0

(Switches the main system clock to the high-frequency clock)

RETI

VINTTC6:

PINTTC6

; INTTC6 vector table

High-frequency clock

Low-frequency clock

Main system clock

SYSCK

TMP86FS49AIUG 数据表(PDF) 45 Page - Toshiba Semiconductor

TMP86FS49AIUG 数据表(HTML) 45 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载