ST7MC1 datasheet(203/308 Pages) STMICROELECTRONICS

203 / 308 page

ST7MC1/ST7MC2

203/308

MOTOR CONTROLLER (Cont’d)

■ 12-bit Mode (PMS bit = 0 in the MPCR register)

This mode is useful for MCMP0 values ranging

from 9 bits to 12 bits. Figure 121 presents the way

Compare 0 and Compare U, V, W should be load-

ed). It requires loading two bytes in the MCMPxH

and MCMPxL registers (i.e. MCMP0, MCMPU,

MCMPV and MCMPW 16-bit registers) following

the sequence described below:

– write to the MCMPxL register (LSB) first

– then write to the MCMPxH register (MSB).

The 16-bit value is then ready to be transferred in

the active register as soon as an update event oc-

curs. This sequence is necessary to avoid poten-

tial conflicts with update interrupts causing the

hardware transfer from preload to active registers:

if an update event occurs in the middle of the

above sequence, the update is effective only when

the MSB has been written.

■ 8-bit PWM mode (PMS bit = 1 in MPCR register)

This mode is useful whenever the MCMP0 value is

less or equal to 8-bits. It allows significant CPU re-

source savings when computing three-phase duty

cycles during PWM interrupt routines. In this

mode, the Compare 0 and Compare U, V, W reg-

isters have the same size (8 bits). The extension of

the MCMPx registers is done in using the OVFx

bits in the MPCR register (refer to Figure 121).

These bits force the related duty-cycles to 100%

and are reset by hardware on occurence of a

PWM update event.

Note about read access to registers with

preload: during read accesses, values read are

the content of the preload registers, not the active

registers.

Note about compare register active bit loca-

tions: the 13 active bits of the MCMPx registers

are left-aligned. This allows temporary calculations

to be done with 16-bit precision, round-up is done

automatically to the 13-bit format when loading the

values of the MCMPx registers.

Note about MCMP0x registers: the configuration

MCMP0H=MCMP0L=0 is not allowed

Figure 121. Comparison between 12-bit and 8-bit PWM mode

OvfX

MCMP0H

MCMP0L

MCMPxH

MCMPxL

Ext

MCMP0H

MCMP0L

MCMPxH

MCMPxL

MPCR

12-bit PWM mode

(PMS bit = 0)

8-bit PWM mode

(PMS bit = 1)

OvfW

OvfV

OvfU

Ext

Bit not available

Bit extending comparison range

Equivalent bit location

PWM frequency

set-up

Phase x duty

cycle set-up

PWM frequency

set-up

Phase x duty

cycle set-up

ST7MC1 数据表(PDF) 203 Page - STMicroelectronics

ST7MC1 数据表(HTML) 203 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载