T48C862-R4 datasheet(19/107 Pages) ATMEL

19 / 107 page

T48C862-R4 [Preliminary]

4551C–4BMCU–01/04

Interrupt Processing

For processing the eight interrupt levels, the microcontroller includes an interrupt con-

troller with two 8-bit wide interrupt pending and interrupt active registers. The interrupt

controller samples all interrupt requests during every non-I/O instruction cycle and

latches these in the interrupt pending register. If no higher priority interrupt is present in

the interrupt active register, it signals the CPU to interrupt the current program execu-

tion. If the interrupt enable bit is set, the processor enters an interrupt acknowledge

cycle. During this cycle a short call (SCALL) instruction to the service routine is exe-

cuted and the current PC is saved on the return stack. An interrupt service routine is

completed with the RTI instruction. This instruction resets the corresponding bits in the

interrupt pending/active register and fetches the return address from the return stack to

the program counter. When the interrupt enable flag is reset (triggering of interrupt rou-

tines is disabled), the execution of new interrupt service routines is inhibited but not the

logging of the interrupt requests in the interrupt pending register. The execution of the

interrupt is delayed until the interrupt enable flag is set again. Note that interrupts are

only lost if an interrupt request occurs while the corresponding bit in the pending register

is still set (i.e., the interrupt service routine is not yet finished).

It should be noted that automatic stacking of the RBR is not carried out by the hardware

and so if ROM banking is used, the RBR must be stacked on the expression stack by

the application program and restored before the RTI. After a master reset (power-on,

brown-out or watchdog reset), the interrupt enable flag and the interrupt pending and

interrupt active register are all reset.

Interrupt Latency

The interrupt latency is the time from the occurrence of the interrupt to the interrupt

service routine being activated. This is extremely short (taking between 3 to 5 machine

cycles depending on the state of the core).

Figure 14.

Interrupt Handling

INT5 active

INT7 active

INT2 pending

SWI0

INT2 active

INT0 pending

INT0 active

INT2

RTI

INT5

INT3 active

INT3

RTI

INT7

Time

Main /

Autosleep

Main /

Autosleep

T48C862-R4 数据表(PDF) 19 Page - ATMEL Corporation

T48C862-R4 数据表(HTML) 19 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载