HD64F2149YV datasheet(73/1075 Pages) RENESAS

73 / 1075 page

Section 2 CPU

Rev. 3.00 Jan 18, 2006 page 45 of 1044

REJ09B0280-0300

(3) Condition-Code Register (CCR)

This 8-bit register contains internal CPU status information, including an interrupt mask bit (I) and

half-carry (H), negative (N), zero (Z), overflow (V), and carry (C) flags.

Bit 7—Interrupt Mask Bit (I): Masks interrupts other than NMI when set to 1. (NMI is accepted

regardless of the I bit setting.) The I bit is set to 1 by hardware at the start of an exception-

handling sequence. For details, refer to section 5, Interrupt Controller.

Bit 6—User Bit or Interrupt Mask Bit (UI): Can be written and read by software using the

LDC, STC, ANDC, ORC, and XORC instructions. This bit can also be used as an interrupt mask

bit. For details, refer to section 5, Interrupt Controller.

Bit 5—Half-Carry Flag (H): When the ADD.B, ADDX.B, SUB.B, SUBX.B, CMP.B, or NEG.B

instruction is executed, this flag is set to 1 if there is a carry or borrow at bit 3, and cleared to 0

otherwise. When the ADD.W, SUB.W, CMP.W, or NEG.W instruction is executed, the H flag is

set to 1 if there is a carry or borrow at bit 11, and cleared to 0 otherwise. When the ADD.L,

SUB.L, CMP.L, or NEG.L instruction is executed, the H flag is set to 1 if there is a carry or

borrow at bit 27, and cleared to 0 otherwise.

Bit 4—User Bit (U): Can be written and read by software using the LDC, STC, ANDC, ORC, and

XORC instructions.

Bit 3—Negative Flag (N): Stores the value of the most significant bit (sign bit) of data.

Bit 2—Zero Flag (Z): Set to 1 to indicate zero data, and cleared to 0 to indicate non-zero data.

Bit 1—Overflow Flag (V): Set to 1 when an arithmetic overflow occurs, and cleared to 0

otherwise.

Bit 0—Carry Flag (C): Set to 1 when a carry occurs, and cleared to 0 otherwise. Used by:

• Add instructions, to indicate a carry

• Subtract instructions, to indicate a borrow

• Shift and rotate instructions, to store the carry

The carry flag is also used as a bit accumulator by bit-manipulation instructions.

Some instructions leave some or all of the flag bits unchanged. For the action of each instruction

on the flag bits, refer to appendix A.1, Instruction.

HD64F2149YV 数据表(PDF) 73 Page - Renesas Technology Corp