| 数据搜索系统,热门电子元器件搜索 |
|
5222-DS02-R 数据表(PDF) 42 Page - Broadcom Corporation. |
|
|
|||||||||||||||||||||||||||||
5222-DS02-R 数据表(HTML) 42 Page - Broadcom Corporation. |
|
42 / 76 page ![]() BCM5222 Preliminary Data Sheet 7/20/04 Broadcom Corporation Page 30 100BASE-TX Auxiliary Status Register Document 5222-DS02-405-R 100BASE-TX AUXILIARY STATUS REGISTER LOCKED The PHY returns a 1 in bit 9 when the descrambler is locked to the incoming data stream. Otherwise it returns a 0. CURRENT 100BASE-TX LINK STATUS The PHY returns a 1 in bit 8 when the 100BASE-TX link status is good. Otherwise it returns a 0. REMOTE FAULT The PHY returns a 1 while its link partner is signalling a far-end fault condition. Otherwise it returns a 0. FALSE CARRIER DETECTED The PHY returns a 1 in bit 5 of the Extended Status register if a false carrier has been detected since the last time this register was read. Otherwise it returns a 0. Table 16: 100BASE-X Auxiliary Status Register (Address 17d, 11h) Bit Name R/W Description Default 15:10 Reserved RO Ignore when read 00h 9 Locked RO 1 = Descrambler locked 0 = Descrambler unlocked 0 8 Current 100BASE-X Link Status RO 1 = Link pass 0 = Link fail 0 7 Remote Fault RO 1 = Remote fault detected 0 = No remote fault detected 0 6 Reserved RO Ignore when read 0 5 False Carrier Detected RO LH 1 = False carrier detected since last read 0 = No false carrier since last read 0 4 Bad ESD Detected RO LH 1 = ESD error detected since last read 0 = No ESD error since last read 0 3 Receive Error Detected RO LH 1 = Receive error detected since last read 0 = No receive error since last read 0 2 Transmit Error Detected RO LH 1 = Transmit error code received since last read 0 = No transmit error code received since last read 0 1 Lock Error Detected RO LH 1 = Lock error detected since last read 0 = No lock error since last read 0 0 MLT3 Code Error Detected RO LH 1 = MLT3 code error detected since last read 0 = No MLT3 code error since last read 0 Note: R/W = Read/Write, RO = Read only, SC = Self Clear, LL = Latched Low, LH = Latched High, LL & LH Clear after read operation. Use default values of reserved bit(s) when writing to reserved bit(s). |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |