HD64F2149YV datasheet(143/1075 Pages) RENESAS

143 / 1075 page

Section 5 Interrupt Controller

Rev. 3.00 Jan 18, 2006 page 115 of 1044

REJ09B0280-0300

5.3

Interrupt Sources

Interrupt sources comprise external interrupts (NMI and IRQ7 to IRQ0) and internal interrupts.

5.3.1

External Interrupts

There are nine external interrupt sources from 33 input pins (31 actual pins): NMI,

IRQ7 to IRQ0,

KIN15 to KIN0, and WUE7 to WUE0. WUE7 to WUE0 and KIN15 to KIN8 share the IRQ7

interrupt source, and KIN7 to KIN0 share the IRQ6 interrupt source. Of these, NMI, IRQ7, IRQ6,

and IRQ2 to IRQ0 can be used to restore the H8S/2149 chip from software standby mode.

NMI Interrupt: NMI is the highest-priority interrupt, and is always accepted by the CPU

regardless of the interrupt control mode and the status of the CPU interrupt mask bits. The

NMIEG bit in SYSCR can be used to select whether an interrupt is requested at a rising edge or a

falling edge on the NMI pin.

The vector number for NMI interrupt exception handling is 7.

IRQ7 to IRQ0 Interrupts: Interrupts IRQ7 to IRQ0 are requested by an input signal at pins

IRQ7

IRQ0. Interrupts IRQ7 to IRQ0 have the following features:

• Using ISCR, it is possible to select whether an interrupt is generated by a low level, falling

edge, rising edge, or both edges, at pins

IRQ7 to IRQ0.

• Enabling or disabling of interrupt requests IRQ7 to IRQ0 can be selected with IER.

• The interrupt control level can be set with ICR.

• The status of interrupt requests IRQ7 to IRQ0 is indicated in ISR. ISR flags can be cleared to 0

by software.

A block diagram of interrupts IRQ7 to IRQ0 is shown in figure 5.3.

HD64F2149YV 数据表(PDF) 143 Page - Renesas Technology Corp