RM0352 datasheet(94/138 Pages) STMICROELECTRONICS

94 / 138 page

I2C bus interface

RM0352

94/138

DocID024647 Rev 1

Note:

The reset value is valid only when I2C frequency equal to 48 MHz. If frequency changes the

user must program the register and this value must be greater than 4.

To set the timing register we use

Equation 3.

•

Standard, fast-mode and fast-mode plus:

Equation 3

Thd-dat = N * Ti2c-clk + Pad_delay

with:

N: value to be programmed

Thd-dat: value required by I2C standard

Pad_delay: Pad delay

10.2.15

I2C hold time START condition F/S (I2C_THDSTA_FST_STD)

Table 85. I2C hold time START condition F/S (I2C_THDSTA_FST_STD)

Address:

I2CBaseAddress + 0x050

Type:

Reset:

0x003F00E2

Description:

The I2C_THDSTA_FST_STD register, that controls the hold time START

condition for F/S mode. The register is read-write.

[8:0] I2C_THDDAT: hold time data value

In master or slave mode, when the I

C controller detect a failing edge in SCL

line, the counter, which is loaded by the I2C_THDDAT, is launched. Once the

I2C_THDDAT value is reached, the data is transferred.

I2C hold time START condition F/S (I2C_THDSTA_FST_STD)

30 29

28 27

23 22 21 20 19 18 17

15 14

RESERVED

I2C_THDSTA_FST

RESERVED

I2C_THDSTA_STD

RRW

[24:16] I2C_THDSTA_FST: hold time START condition value for fast mode. When

the START condition is asserted, the decimeter loads the value of the

I2C_THDSTA_FST for fast mode, once the I2C_THDSTA_FST value is

reached the SCL line asserts low.

[8:0] I2C_THDSTA_STD: hold time START condition value for standard mode

When the START condition is asserted, the decimeter loads the value of

I2C_THDSTA_STD for standard mode, once the I2C_THDSTA_STD value is

reached the SCL line asserts low.

RM0352 数据表(PDF) 94 Page - STMicroelectronics

RM0352 数据表(HTML) 94 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载