RM0352 datasheet(33/138 Pages) STMICROELECTRONICS

33 / 138 page

DocID024647 Rev 1

33/138

RM0352

Embedded Flash memory

137

The CMDDONE and CMDSTART bits are updated a few clock cycles after the requested

command has been started by writing to the COMMAND register.

Raw status

The raw status register IRQRAW will always show the unmasked condition.

Status

The IRQSTAT register will show the masked version of the raw status register.

Writing an one to the corresponding interrupt status bit will clear the interrupt status bit.

Mask

The mask bit in IRQMASK will mask the condition in the status register IRQSTAT and mask

the generation of the interrupt (output flash_irq).

6.3.2

Data register

The data register needs to be written with:

•

The desired value written to the Flash location.

•

The desired compare value for a (mass) read operation, the flag READOK will indicate

if there was a match or not. For mass read, all read values must match for READOK.

6.3.3

Address register

Address[13:0] = XADR[7:0] & YADR[5:0].

The 14-bit address is aligned on four bytes (32-bit written for each location).

READOK

Mass read was OK.

FLNREADY

Flash not ready (sleep).

Table 19. Flash interrupt register

Bit

Name

Description

RM0352 数据表(PDF) 33 Page - STMicroelectronics

RM0352 数据表(HTML) 33 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载