RM0312 datasheet(222/275 Pages) STMICROELECTRONICS

222 / 275 page

Serial peripheral interface (SPI)

RM0312

222/275

DocID022352 Rev 3

20.4.4

SPI status register (SPI_SR)

Address offset: 0x03

Reset value: 0x02

654

3210

BSY

OVR

MODF

Reserved

WKUP

Reserved

TXE

RXNE

rc_w0

Bit 7 BSY: Busy flag

0: SPI not busy

1: SPI is busy in communication

This flag is set and reset by hardware.

Note: BSY flag must be used with cautious: refer to Section 20.3.6: Status flags on page 214 and

Section 20.3.7: Disabling the SPI on page 215

Bit 6 OVR: Overrun flag

0: No Overrun occurred

1: Overrun occurred

This flag is set by hardware and reset by a software sequence.

Bit 5 MODF: Mode fault

0: No Mode fault occurred

1: Mode fault occurred

This flag is set by hardware and reset by a software sequence.

Bit 4 Reserved

Bit 3 WKUP: Wakeup flag

0: No wakeup event occurred

1: Wakeup event occurred

This flag is set on the first sampling edge on SCK when the STM8 is in Halt mode and the SPI is

configured as slave.

This flag is reset by software writing 0.

Bit 2 Reserved

Bit 1 TXE: Transmit buffer empty

0: Tx buffer not empty

1: Tx buffer empty

Bit 0 RXNE: Receive buffer not empty

0: Rx buffer empty

1: Rx buffer not empty

RM0312 数据表(PDF) 222 Page - STMicroelectronics

RM0312 数据表(HTML) 222 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载