ST7FLCD1 datasheet(76/95 Pages) STMICROELECTRONICS

76 / 95 page

Watchdog Timer (WDG)

ST7FLCD1

76/95

The T6 bit can be used to generate a software reset (the WDGA bit is set and the T6 bit is cleared).

The application program must write in the CR register at regular intervals during normal operation to

prevent an MCU reset. The value to be stored in the CR register must be between FFh and C0h

(see Table 25).

12.4

Lock-up Counter

An 8-bit counter starts after a reset or by writing to the CR register. It disables the writing of the CR

takes place during this time, this 8-bit counter is reset but not the main watchdog downcounter (no

writing to the CR register occurs).

Thus after several too close writings of the CR register, the main downcounter reaches the reset

value and a reset occurs. If the CR register is normally refreshed every 32 µs or more, write

commands are always enabled.

12.5

Interrupts

None.

12.6

WDG CONTROL REGISTER (WDGCR)

Read/Write

Reset Value: 2 1111 (7Fh)

Bit 7 = WDGA Activation bit.

This bit is set by software and only cleared by hardware after a reset. When WDGA = 1, the

watchdog can generate a reset.

Watchdog disabled

Watchdog enabled

Bits [6:0] = T[6:0] 7-bit Timer (MSB to LSB).

These bits contain the decremented value. A reset is produced when it rolls over from 40h to 3Fh

(T6 is cleared).

Table 25: Watchdog Timing (fCPU = 8 MHz)

CR Register Initial Value

WDG Timeout (ms)

Lock-up Timeout (µs)

Maximum

FFh

400

Minimum

C0h

6.250

Table 26: Watchdog Register Map

Address

Reset

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

001Bh

R/W

WDGCR

WDGA

T[6:0]

321

WDGA

ST7FLCD1 数据表(PDF) 76 Page - STMicroelectronics

ST7FLCD1 数据表(HTML) 76 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95

数据表下载