STM8S datasheet(118/467 Pages) STMICROELECTRONICS

118 / 467 page

Auto-wakeup (AWU)

RM0016

118/467

DocID14587 Rev 14

12.4

AWU registers

12.4.1

Control/status register (AWU_CSR)

Address offset: 0x00

Reset value: 0x00

654

3210

Reserved

AWUF

AWUEN

Reserved

MSR

rrc_r

Bits 7:6 Reserved

Bit 5 AWUF: Auto-wakeup flag

This bit is set by hardware when the AWU module generates an interrupt and cleared by reading the

AWU_CSR register. Writing to this bit does not change its value.

0: No AWU interrupt occurred

1: AWU interrupt occurred

Bit 4 AWUEN: Auto-wakeup enable

This bit is set and cleared by software. It enables the auto-wakeup feature. If the microcontroller enters

Active-halt or Wait mode, the AWU feature wakes up the microcontroller after a programmable time

delay.

0: AWU (Auto-wakeup) disabled

1: AWU (Auto-wakeup) enabled

Bits 3:1 Reserved

Bit 0 MSR: Measurement enable

This bit connects the fLS clock to a timer input capture. This allows the timer to be used to measure the

LS frequency (fLS).

0: Measurement disabled

1: Measurement enabled

Note: Refer to the datasheet for information on which timer input capture can be connected to the LSI

clock in the specific product).

STM8S 数据表(PDF) 118 Page - STMicroelectronics

STM8S 数据表(HTML) 118 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载